199001701 - 2127C52 ODD AND EVEN GEAR ENGAGEMENT SOLENOIDS - R.R.
Removing
(
Refitting
)
Op. 5530B10 BATTERY - R+R Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R Op. 2127C13 HEAT PROTECTION BULKHEAD ON GEARBOX HYDRAULIC CIRCUIT FLUID RESERVOIR WITH ELECTRO-HYDRAULIC SELECTION - R.R. Op. 2127C40 HYDRAULIC SPEED SELECTION HYDRAULIC ACTUATOR UNIT AND CLUTCH - R.R. 1. Disconnect the electrical connections (1a) and (1b), loosen the bolts (1c) and remove the even and uneven gear engagement solenoid valves (1d).| Description | Connector | |
|---|---|---|
| 1a | Solenoid valve 1 (gear engagement) | See L051 SOLENOID 1 (GEAR ENGAGEMENT) |
| Description | Connector | |
|---|---|---|
| 1b | Solenoid valve 2 (gear engagement) | See L052 SOLENOID 2 (GEAR ENGAGEMENT) |
Refitting
(
Removing
)
- Fit a new O-ring in the special goove in the even and uneven gear engagement solenoid valve seat.- Fit the even and uneven gear engagement solenoid valves in their seats and tighten the fixing bolts.- Connect the electrical connections for the even and uneven gear engagement solenoid valves. Op. 2127C40 HYDRAULIC SPEED SELECTION HYDRAULIC ACTUATOR UNIT AND CLUTCH - R.R. Op. 0010T47 HYDRAULIC SYSTEM FLUID FOR GEARBOX WITH HYDRAULIC SELECTION CHECK LEVEL AND TOP UP, IF NECESSARY Op. 0010T48 HYDRAULIC SYSTEM FOR GEARBOX WITH HYDRAULIC SELECTION - BLEED AIR Op. 2127C13 HEAT PROTECTION BULKHEAD ON GEARBOX HYDRAULIC CIRCUIT FLUID RESERVOIR WITH ELECTRO-HYDRAULIC SELECTION - R.R. Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R Op. 5530B10 BATTERY - R+R - Connect the Examiner and run the initialisation procedure for the gear selector/engagement position settings and check that the engagement position travel is correct.