199001703 - 2127C56 CLUTCH CONTROL SOLENOID - R.R.

Removing ( Refitting )     Op. 5530B10 BATTERY - R+R     Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R     Op. 2127C13 HEAT PROTECTION BULKHEAD ON GEARBOX HYDRAULIC CIRCUIT FLUID RESERVOIR WITH ELECTRO-HYDRAULIC SELECTION - R.R.    Op. 2127C40 HYDRAULIC SPEED SELECTION HYDRAULIC ACTUATOR UNIT AND CLUTCH - R.R. 1. Disconnect the electrical connection (1a), undo the bolts (1b) and remove the clutch control solenoid valve (1c).

	Description	Connector
1a	Clutch control solenoid valve	See L056 CLUTCH CONTROL SOLENOID

2. Remove the O-ring. Refitting ( Removing ) - Fit a new O-ring in the special groove in the clutch control solenoid valve seat.- Fit the clutch control solenoid valve in its seat and tighten the fixing bolts.- Connect the electrical connection for the clutch control solenoid valve.    Op. 2127C40 HYDRAULIC SPEED SELECTION HYDRAULIC ACTUATOR UNIT AND CLUTCH - R.R.     Op. 0010T47 HYDRAULIC SYSTEM FLUID FOR GEARBOX WITH HYDRAULIC SELECTION CHECK LEVEL AND TOP UP, IF NECESSARY     Op. 0010T48 HYDRAULIC SYSTEM FOR GEARBOX WITH HYDRAULIC SELECTION - BLEED AIR     Op. 2127C13 HEAT PROTECTION BULKHEAD ON GEARBOX HYDRAULIC CIRCUIT FLUID RESERVOIR WITH ELECTRO-HYDRAULIC SELECTION - R.R.    Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R     Op. 5530B10 BATTERY - R+R - Connect the Examiner and run the initialisation procedure for the gear selector/engagement position settings and check that the engagement position travel is correct.