199002897 - B0102 Connec. to ECU container ground

To apply this procedure, the following must be borne in mind:1 - Measurements cannot be taken on the Air Bag wiring.2 - The system fault diagnosis is started leaving the vehicle charges connected.3- The fault should be "Present" or "Present Intermittently" and not "Intermittent". If the fault is Intermittent then the Procedure is not applicable; proceed with an accurate check on the line where the fault was signalled.4 - Not all the simulation sensors are available (e.g. side impact sensors).

The airbag fault warning light is controlled by a dedicated connection to the airbag control unit Instrument Panel Node.

The Air Bag wiring is a safety component. If there are problems with the cables or the connectors then the wiring should be replaced in one piece.

		Test results
1	RESTORING CONTINUITY	All OK	Problems encountered	Operation
	Turn the ignition key to the OFF position. Restore the continuity between the container for the control unit and the vehicle earth removing the paint or traces of oxide on the nuts/bolts securing the control unit to the bracket and the latter to the vehicle bodywork	Move on to Step 2	-	-
2	CHECK ON CORRECT OPERATION	All OK	Problems encountered	Operation
	Check that the diagnostic equipment is not signalling other faults	End of diagnosis	The diagnostic equipment is signalling other faults	Proceed as instructed in the    See table K080 AIRBAG FAILURE WARNING LIGHT ON