199001649 - 3330C34 BRAKE FLUID RESERVOIR - R + R AND WASH INSIDE - VERSIONS WITH RIGHT HAND DRIVE AND ABS

Removing ( Refitting )     Op. 1044B10 FUEL FILTER ASSEMBLY - R + R OR REPLACE 1. Undo the cap and tighten the tool onto the brake/clutch fluid reservoir.

Tool	Description	Function	Validity
2000001400	Plug	Brake/ clutch system vacuum

1. Connect a suitable recipient to the bleed valve of one front brake caliper.2. Loosen the bleed valve and pump the brake pedal several times to drain the fluid out of the brake fluid reservoir. 1. Disconnect the rapid connectors and remove the hoses from the brake pump. 1. Disconnect from the reservoir the hose for the clutch pump.2. Detach the electrical connection for the brake fluid minimum warning light switch.

	Description	Connector
2	Brake fluid level sensor (switch)	See K025 BRAKE FLUID LEVEL SENSOR (SWITCH)

3. Undo fastenings (3a) and remove reservoir (3b), complete with mounting bracket. - Position the reservoir mounting bracket in a vice fitted with protective jaws.1. Compress spring (1a) and remove minimum brake fluid warning light switch (1b) from the reservoir.2. Compress spring (2a) and separate reservoir (2b) from mounting bracket (2c). Refitting ( Removing ) - Using the retaining clip, connect the reservoir to the mounting bracket.- Place the brake fluid minimum level warning light switch in its housing and secure it with the retaining clip.- Place the reservoir assembly back into the engine compartment and tighten the fastenings to the bodyshell.- Secure the electrical connection for the brake fluid minimum level warning light switch and close the wiring retaining clip.- Apply pressure to connect the hose for the clutch pump to the reservoir.- Secure the rapid connectors for the hoses to the brake pump.    Op. 1044B10 FUEL FILTER ASSEMBLY - R + R OR REPLACE     Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY     Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR