1072B50 AIR CHAMBER - R.R. - Fiat - GRANDE PUNTO - eLearn

199002367 - 1072B50 AIR CHAMBER - R.R.

) - Position the vehicle on a lift. Op. 5530B10 BATTERY - R+R Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R Op. 1080C82 E.G.R. - VALVE HEAT EXCHANGER ASSEMBLY - CONNECTOR PIPES - R.R. 1. Undo the bolts (1a), loosen the band and disconnect the oil vapour recovery pipe between the rigid pipe and the separator (1b), separator side.

1. Undo the bolt (1a) and disconnect the connector (1b) for the engine oil vapour recovery pipe from the timing cover.2. Undo the bolt (2a) and remove the engine oil dipstick tube assembly (2b).

1. Loosen the band and disconnect the oil recovery pipe, separator side.2. Unscrew the bolts (2a) and remove the engine oil vapour separator (2b) complete with engine oil vapour recovery pipe (2c).

1. Disconnect the electrical connection for the pressure relief sensor.

	Description	Connector
1	Supercharging sensor	See K082 SUPERCHARGING SENSOR

- Release the electrical wiring from the bands on the air chamber.1. Undo the bolts (1a) and remove the air chamber (1b) complete with gasket (1c) and pressure relief sensor.

Refitting ( Removing

) - Refit the air chamber complete with gasket and pressure relief sensor back in its housing and secure it tightening the bolts to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Intake manifold	Bolt	M8	2.3 ÷ 2.8	1.3 Multijet

- Fasten the electrical wiring using the bands on the air chamber.- Connect the electrical connection for the pressure relief sensor.- Replace the engine oil vapour separator wiht engine oil vapour recovery pipe in its seat and secure it with the bolts.- Connect the oil vapour recovery pipe, separator side and tighten the band.- Place the engine oil dipstick pipe back in its housing and fasten it with the bolt.- Connect the connector for the engine oil vapour recovery pipe to the timing cover and tighten the bolt.

Ensure the O-ring is present and correctly positioned.

- Connect the oil vapour recovery pipe between the rigid pipe and the separator, separator side, then tighten the band and the bolts. Op. 1080C82 E.G.R. - VALVE HEAT EXCHANGER ASSEMBLY - CONNECTOR PIPES - R.R. Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R Op. 5530B10 BATTERY - R+R - Remove the vehicle from the lift.