199002320 - 0010T12 ENGINE OIL AND FILTER - REPLACE

Engine oil is harmful to skin: keep contact with skin to a minimum and if there is contact wash with soap and water.

- Position the vehicle on a lift.1. Remove the filler cap with the engine hot.2. Release the engine oil dipstick. 1. Undo the drain plug in the crankcase sump and leave the oil to drain into a suitable container.

Be very careful when removing the drain plug, the oil could be very hot.

Do not let the oil disperse into the environment as indiscriminate dispersion of this product causes pollution.

- Undo the bolts and remove the upper protection for the cartridge engine oil filter.1. Undo the cartridge engine oil filter cover (1a) complete with o-ring (1b) and remove it.2. Undo and remove the cartridge engine oil filter. - Clean the drain plug and tighten the gasket to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Engine oil drain plug	-	M14	1.8 ÷ 2.2	1.3 Multijet1.9 Multijet

- Place a new engine oil filter cartridge in its housing.- Place the cartridge engine oil filter cover complete with new O-rings in its housing and tighten it.- Refill the engine lubrication circuit with the recommended oil.

Component	Type	Description	Classification	Qty.	Validity
ENGINE LUBRICATION CIRCUIT	Oil [l]	SELENIA WR	SAE 5W-40 - FIAT 9.55535-M2	3.2	1.3 Multijet

The table shows the quantity for periodic replacement.

- Check that the engine oil level is correct using the dipstick.

The oil level is checked with the vehicle on a flat surface.

- Fit the filler cap, let the engine idle for about 2 minutes, switch off the engine and then wait for several minutes.- Check the oil level and make sure there are no leaks.

Proceed with the renewal operations using the Examiner.

- Remove the vehicle from the lift.