199000426 - 1016E14 VALVE GUIDES IN SINGLE CYLINDER HEAD - REPLACE DURING OP. 1016E10

Removing ( Refitting ) 1. Remove the valve guides (1a) using the tool (1b).
ToolDescriptionFunctionValidity
1870880000Extractor/ fitting toolValve guide extraction1.3 Multijet
Refitting ( Removing ) - Check that the outer diameter of the valve guides to be fitted corresponds to the recommended figures.
MeasurementValueValidity
Valve guide outer diameter (mm)10.010 ÷ 10.0301.2 8v1.4 8v1.4 16v1.3 Multijet
MeasurementValueValidity
Valve guide outer diameter oversize (mm)0.05/0.10/0.251.4 16v1.3 Multijet
1. Fit the new valve guides (1a) using the tool (1b).
ToolDescriptionFunctionValidity
1870900900Extractor/ fitting toolValve guide fitting1.3 Multijet
The valve guides should be fitted after the cylinder head has been heated to a temperature of 80° - 100°C.
- Ream the valve guide inner diameter to the recommended figure.
MeasurementValueValidity
Valve guide inner diameter (mm)6.020 ÷ 6.0381.3 Multijet