199000403 - 1004D40 ENGINE - POSITION ON STAND AND REMOVE

1. Keep the flywheel lock fitted, refere to    Op. 1004D10 POWER UNIT (MANUAL GEARBOX), REMOVED, DISMANTLE AND REASSEMBLE
ToolDescriptionFunctionValidity
1860846000Counter-torqueFlywheel lock
1. Loosen the bolts fixing the crankshaft pulley.2. With the engine timed, refer to    Op. 1004D10 POWER UNIT (MANUAL GEARBOX), REMOVED, DISMANTLE AND REASSEMBLE loosen the left hand thread bolt securing the pulley mounting flange to the crankshaft.
1. Undo the bolts (1a) and remove the engine flywheel (1b).2. Remove the flange.
The bolts fixing the flywheel are pre-treated with sealant, therefore they should be replaced each time they are removed.
3. Remove the flywheel lock.
ToolDescriptionFunctionValidity
1860846000Counter-torqueFlywheel lock
1. Fit the universal tool on the engine block.
ToolDescriptionFunctionValidity
1871001000Rotary stand for overhaulingEngine overhaul1.3 Multijet
- Secure and support the engine using a hydraulic lift fitted with chains.- Position the engine on the overhaul stand using the universal tool fitted previously.
- Release the engine from the hydraulic lift hoist.- Secure and support the engine using a hydraulic lift fitted with chains.- Undo the fastenings securing the universal tool to the overhaul stand, then position the enigne on a special workbench using the hydraulic lift.- Undo the fastenings and remove the universal tool from the engine.1. Fit the flywheel lock.
ToolDescriptionFunctionValidity
1860846000Counter-torqueFlywheel lock
2. Place the engine flywheel (2a), complete with flange (2b), back in its housing and secure it tightening the new bolts (2c) to the recommended torque.
ComponentFasteningdia  Value (daNm)Validity
Engine flywheelBolt (to be replaced)M84.0 ÷ 4.81.2 8v1.4 8v1.3 Multijet
1. With the timing template fitted on the exhaust side camshaft, refer to    Op. 1004D10 POWER UNIT (MANUAL GEARBOX), REMOVED, DISMANTLE AND REASSEMBLE proceed with tightening the left hand thread bolt securing the pulley mounting flange to the crankshaft.
ComponentFasteningdia  Value (daNm)Validity
Pulley support flange on crankshaftLeft hand boltM144.7 ÷ 5.2 + 75° +/- 3°1.3 Multijet
2. Tighten the bolts fixing the crankshaft pulley to the recommended torque.
ComponentFasteningdia  Value (daNm)Validity
Services pulley on crankshaftBoltM82.3 ÷ 2.8