199000516 - 1060F36 PIPES (ALL) FROM FUEL MANIFOLD TO INJECTOR - R.R.

Removing ( Refitting )     Op. 1048A10 AIR FILTER ASSEMBLY - R.R. 1. Manually push the clips (1a) and disconnect the pipe from the injectors to the fuel manifold (1b), injector side.2. Undo the bolts (2a) and move the duct (2b) as necessary. 1. Unscrew the connectors (1a) and remove the pipes from the fuel manifold to the injectors (1b).

Use new pipes from the fuel manifold to the injectors when refitting.

Refitting ( Removing ) - Fit new pipes from the fuel manifold to the injectors and secure with connectors without tightening.- Tighten the connectors for the pipes from the fuel manifold to the injector side injectors to the recommended torque using an appropriate commercial wrench.

Component	Fastening	dia	Value (daNm)	Validity
Pipes from fuel manifold to injectors - injectors side	Connector	M12	2.3 ÷ 2.5	1.3 Multijet

- Tighten the connectors for the pipes from the fuel manifold to the fuel manifold side injectors to the recommended torque using an appropriate commercial wrench.

Component	Fastening	dia	Value (daNm)	Validity
Pipes from fuel manifold to injectors - fuel manifold side	Connector	M14	2.6 ÷ 2.9	1.3 Multijet

Clean the threaded pipe seats on the manifold and injectors with heptane.

- Place the duct back in its housing and secure it using the bolts.- Connect the pipe from the injectors to the fuel manifold, injector side pushing it home until the clips click into place.    Op. 1048A10 AIR FILTER ASSEMBLY - R.R.