199001648 - 3330C12 MASTER CYLINDER (PUMP) - R.R. FOR RIGHT HAND DRIVE VERSIONS

Removing ( Refitting ) 1. Undo the cap and tighten the tool onto the brake/clutch fluid reservoir.

Tool	Description	Function	Validity
2000001400	Plug	Brake/ clutch system vacuum

1. Connect a suitable recipient to the bleed valve of one front brake caliper.2. Loosen the bleed valve and pump the brake pedal several times to drain the fluid out of the brake fluid reservoir.

Mark the position of the rigid pipes on the brake pump.

1. Undo the connectors and disconnect the rigid pipes from the brake pump.2. Disconnect the rapid connectors and remove the hoses from the brake pump.3. Undo nuts (3a) and remove brake pump (3b) complete with O-ring from the brake servo. Refitting ( Removing ) - Place the brake pump complete with new O-ring in its housing and secure it to the brake servo, tightening the nuts to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Master brake cylinder (pump)	Nut	-	1.7 ÷ 2.3

- Connect the rapid connectors for the hoses to the brake pump.- Tighten to the specified torque the connectors for the rigid pipes from the brake pump to the electro-hydraulic control unit.

Component	Fastening	dia	Value (daNm)	Validity
Brake pipe connectors	Connector	M10	1.4 ÷ 1.8

    Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY     Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR