199002540 - 1092A14 PULLEY SUPPORT FLANGE ON CRANKSHAFT - R.R.

Removing ( Refitting ) - Position the vehicle on a lift.    Op. 4450B04 RIGHT FRONT WHEEL - R.R     Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.     Op. 1092G10 SINGLE ENGINE BELT - R.R     Op. 1092A10 CRANKSHAFT PULLEY - R + R 1. Remove plug (1a) and replace it with tool (1b) on the exhaust side camshaft.
Fit the tool positioning it with the millings horizontal and checking that it is correctly inserted in the housing in the camshaft.
ToolDescriptionFunctionValidity
1871000900TemplateEngine tuning1.3 Multijet
2. Fit a suitable (6 mm diameter) peg via the special opening in the gearbox.
Check that the peg is correctly inserted in the housing in the flywheel.
1. Undo the left bolt (1a) fixing the pulley support flange on the crankshaft using tools (1b) and (1c) for counter-torque.
ToolDescriptionFunctionValidity
1871000200Counter-torqueLock crankshaft1.3 Multijet
ToolDescriptionFunctionValidity
1860831000Support for counter-torqueLock crankshaft1.3 Multijet
2. Remove the pulley support flange on the crankshaft.
Refitting ( Removing ) - Refit the pulley mounting flange to crankshaft and tighten the left-threaded bolt to the specified torque using the tools for counter-torque.
ComponentFasteningdia  Value (daNm)Validity
Pulley support flange on crankshaftLeft hand boltM144.7 ÷ 5.2 + 75° +/- 3°1.3 Multijet
ToolDescriptionFunctionValidity
1871000200Counter-torqueLock crankshaft1.3 Multijet
ToolDescriptionFunctionValidity
1860831000Support for counter-torqueLock crankshaft1.3 Multijet
- Remove the peg from the opening in the gearbox.- Remove the exhaust camshaft timing tool and tighten the plug.    Op. 1092A10 CRANKSHAFT PULLEY - R + R     Op. 1092G10 SINGLE ENGINE BELT - R.R     Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.     Op. 4450B04 RIGHT FRONT WHEEL - R.R - Remove the vehicle from the lift.