199003052 - 1060GM CHECK ENGINE CONTROL UNIT CONNECTIONS
| STEP | CHECK TO BE PERFORMED | RESOLUTION IF THE CHECK IS NOT OK |
|---|---|---|
| 1 | Turn the ignition key OFF.Disconnect the wiring harness connector from the fuel pressure sensor. Turn the key ON.Select the following system on the diagnostic equipment: Marelli Diesel Injection 6F3 EOBD CAN (EP engine 1.3 JTD).Check that error PO641 is "Present" | Replace the fuel pressure sensor Op. 1060G28 FUEL PRESSURE SENSOR ON FUEL MANIFOLD TO INJECTORS - R.R |
| 2 | Turn the ignition key OFF.Disconnect the wiring harness connector from the turbo pressure sensor.Turn the ignition key ON.Check that error PO641 is "Present" | Replace the turbo sensor Op. 1060G16 EXCESS PRESSURE SENSOR - R.R. |
| 3 | Turn the ignition key OFF.Disconnect the wiring harness connector from engine control unit connector BTurn the key ON. Check the voltage across control unit Pin 6 (wiring side) See M010 ENGINE MANAGEMENT ECU and the earth is greater than 0.3 V. | Repair or if necessary replace the electrical wiring between the fuel pressure sensor and the engine control unit See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT |
| 4 | Check that the resistance across pin 8 (wiring side) of the control unit See M010 ENGINE MANAGEMENT ECU and the earth is greater than 0.3 V. | Repair or if necessary replace the electrical wiring between the fuel pressure sensor and the engine control unit See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT |
| 5 | Turn the ignition key OFF.Check that the resistance between pin 8 (wiring side) of the control unit See M010 ENGINE MANAGEMENT ECU and the earth is more than 500 kOhm. | Repair or if necessary replace the electrical wiring between the fuel pressure sensor and the engine control unit See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT |
| 6 | Turn the ignition key ON.Check that the resistance across pin 24 (wiring side) of the control unit See M010 ENGINE MANAGEMENT ECU and the earth is greater than 0.3 V. | Repair or if necessary replace the electrical wiring between the excess pressure sensor and the engine control unit See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT |
| 7 | Check that the resistance across pin 23 (wiring side) of the control unit See M010 ENGINE MANAGEMENT ECU and the earth is greater than 0.3 V. | Repair or if necessary replace the electrical wiring between the excess pressure sensor and the engine control unit See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT |
| 8 | Turn the ignition key OFF.Check that the resistance between pin 23 (wiring side) of the control unit See M010 ENGINE MANAGEMENT ECU and the earth is more than 500 kOhm. | Repair or if necessary replace the electrical wiring between the excess pressure sensor and the engine control unit See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT |
| 9 | Replace the engine management control unit Op. 1060G80 DIESEL ELECTRONIC INJECTION CONTROL UNIT - R.R |