199004883 - 2127EE CHECKING THE ROBOTIZED GEARBOX CONTROL UNIT POWER SUPPLY (Robotized gearbox)

STEP	CHECK TO BE PERFORMED REMEDIAL ACTION	IF THE CHECK IS NOT OK
1	Check on +30 power supplyConnect a voltmeter between pin 3 of connector A of the gearbox control unit and earthCheck that the battery voltage is 12VCheck the continuity of fuse F39 from 15 A located on the engine compartment control unit    See E7051 ROBOTIZED GEARBOX Move on to Step 2	Replace fuse F39 after identifying what caused it to blow. Restore the wiring between the junction unit and the gearbox control unit
2	+15 ignition supply checkTurn the key ON. Connect a voltmeter between pin 10 of connector A of the gearbox control unit and earth. Check that the battery voltage is 12V. Check the continuity of fuse F23 from 7.5 A located on the engine compartment control unit.    See E7051 ROBOTIZED GEARBOX Move on to Step 3	Replace the fuse F23 after having identified what caused it to blowRestore the wiring between the junction unit and the gearbox control unit
3	Earth points connection checkDisconnect the negative battery leadDisconnect hydraulic unit control unit (C)Check earth strips (M) are properly connected to the electrohydraulic unit control unit (as shown in the figure). Check that the earth strips are not deformed/damaged.Check that the gearbox control unit is correctly earthed via the above points on the hydraulic unit and that the gearbox control unit connections are not damaged	Restore the earth strips, if necessary replace electrohydraulic unitReplace the gearbox control unit    Op. 2127E10 HYDRAULIC SPEED SELECTION SYSTEM CONTROL UNIT - R.R. if the connections are damaged

Electronic control unitCONNECTOR A (vehicle side)1. Not connected2. Driver''s door switch signal3. Vbat for TCU4. Reversing lights output signal5. Vbat for electric pump6. Not connected7. Selector lever position 38. Not connected9. Brake pedal signal10. TCU activation signal (key-on: +15)11. Selector lever position 212. Selector lever position 113. Selector lever earth14. Not connected15. Not connected16. Selector lever position 417. ECO switch18. Not connected19. CAN L (high speed)20. CAN L (high speed)21. Not connected22. CAN H (high speed)23. CAN H (high speed)from 24. to 28. Not connectedCONNECTOR B (system side)1. Pump motor control2. Not connected3. Gearbox speed sensor (-)4. Engagement sensor and selection sensor power supply (+5V)5. Engagement position signal6. Engagement and selection position sensor reference earth7. Not connected8. Gearbox speed sensor (+)9. Clutch position sensor power supply (+5V)10. Clutch position signal11. Clutch earth reference12. Selection position signalC - Gearbox control unitM - Earth strops for gearbox control unit on hydraulic unit