199003118 - P0194 Pressure sensor on injectors support signal (75 CV)

The error is detected if the electrical value is within the range, but the signal is not plausible because the pressure is lower than an absolute minimum threshold
Test results
1INTAKE CIRCUIT CHECKAll OKProblems encounteredOperation
Check that the intake circuit is working properly by carrying out the    See Test 1048OA AIR INTAKE/VACUUM CIRCUIT CHECKMove on to Step 2--
2AMBIENT PARAMETERS CHECKAll OKProblems encounteredOperation
Select the following control unit at the diagnostic equipment: Marelli Diesel Injection 6F3 EOBD CAN (EP engine 1.3 JTD).Check the value of the following parameters:. Atmospheric pressure    See Test 1060GD ATMOSPHERIC PRESSURE CHECK- Supercharging pressure measured    See Test 1060GF SUPERCHARGING PRESSURE CHECKMove on to Step 3--
3PRESSURE SENSOR REPLACEMENTAll OKProblems encounteredOperation
The pressure sensor on the flute is blocked, replace    Op. 1060G28 FUEL PRESSURE SENSOR ON FUEL MANIFOLD TO INJECTORS - R.R End of diagnosis