199003185 - U0001 CAN line error

The error is detected if the CAN is faulty, in other words there is a short circuit between the High and Low CAN, a short circuit to +Vbatt. of the Low CAN or a short circuit to earth of the High CAN (with detail Bus off), no messages from all the nodes (with detail Mute) or through a diagnostic test of the message frame with detection of the CAN controller broken (with detail condition recorded).
In the case of a fault at the CAN error code U0426 is also memorized and starting is inhibited
Test results
1ERROR DETAIL CHECKAll OKProblems encounteredOperation
Check on the diagnostic equipment that the detail for error U0001 is "BUS off"Move on to Step 2The detail is "condition recorded"Replace the engine management control unit    Op. 1060G28 FUEL PRESSURE SENSOR ON FUEL MANIFOLD TO INJECTORS - R.R
The detail is "Mute"Move on to Step 3
2CAN CHECKAll OKProblems encounteredOperation
Check that there are no connection faults between the other control units in the CAN In particular, that there are no open circuit or short circuit problems    See E1050 CAN CONNECTION LINES End of diagnosisThere are faulty connectionsRestore or, if necessary, replace the wiring
3ENGINE CONTROL UNIT CONNECTION CHECKAll OKProblems encounteredOperation
Check that the CAN connections between the engine management control unit and the Body Computer are not faulty. In particular, that there are no open circuit or short circuit problems    See E1050 CAN CONNECTION LINES End of diagnosisThere are faulty connectionsRestore or, if necessary, replace the wiring