199000475 - 1040A14 FUEL TANK - R + R FOR REPLACEMENT

Removing ( Refitting ) - Position the vehicle on a lift.- Disconnect the negative battery terminal.- Fold the rear seat cushion over.1. Use tool to release and remove the access cover to the fuel pump assembly.
Position the tool and apply leverage as indicated in the lever to prevent the cover tab deforming.
1. Disconnect the electrical connection (1a) and remove the fuel supply and return pipes (1b).
DescriptionConnector
1aFuel pump and level gauge    See N040 FUEL PUMP AND LEVEL GAUGE
- Raise the vehicle.    Op. 1076A51 HEAT SHIELD FOR EXHAUST PIPE ON FUEL TANK - R.R1. Loosen the band and disconnect the blow back pipe from the fuel filler pipe.2. Open the bands securing the blow back pipe to the fuel fillter pipe.3. Open the band and disconnect the fuel filler pipe from the tank.
Using a suitable plug, close the connector for the fuel filler pipe on the tank.
1. Open the clips (1a) and disconnect the brake pipes (1b) on the left and right sides of the tank.2. Position a hydraulic jack with a suitable support under the fuel tank.3. Undo the bolts (3a) and remove the fuel tank (3b).
1. Fit the tool (1a), undo the ring nut (1b) securing the submerged pump assembly (1c) from the tank and remove it with the seal (1d).
ToolDescriptionFunctionValidity
1870736000SpannerLoosen/ tighten ring nut securing submerged pump assembly complete with level gauge control
- Proceed with transferring the fuel using suitable equipment. Refitting ( Removing ) 1. Fit a new seal on the tank.2. Place the submerged pump assembly (2a) back in its housing taking care to ensure that the arrow (2b) stamped on the pump is aligned with the splining (2c) on the tank.3. Tighten the ring nut (3a) securing the pump assembly using the tool (3b).
ToolDescriptionFunctionValidity
1870736000SpannerLoosen/ tighten ring nut securing submerged pump assembly complete with level gauge control
- Fit the fuel tank and tighten the bolts to the recommended torque.
ComponentFasteningdia  Value (daNm)Validity
Fuel tankBoltM83.2 ÷ 3.9
- Remove the hydraulic jack and the support positioned underneath the fuel tank.- Connect the brake pipes on the left and right sides of the tank and close the clips.- Connect the fuel filler pipe to the tank and close the band.- Connect the blow back pipe to the fuel filler pipe, close the clips and the band.    Op. 1076A51 HEAT SHIELD FOR EXHAUST PIPE ON FUEL TANK - R.R- Lower the vehicle.- Place the fuel supply and return pipes in their housings.- Connect the electrical connection to the fuel pump assembly.- Place the access cover to the fuel pump assembly back in its housing.- Place the rear seat cushion back in position.- Connect the negative battery terminal.- Remove the vehicle from the lift.