199000935 - 1820B38 HYDRAULIC CLUTCH ACTUATOR WITH COAXIAL CONTROL - R.R WITH GEARBOX REMOVED

Removing ( Refitting ) 1. Withdraw the retaining clip (1a) and remove the hydraulic clutch actuator fitting (1b). 1. Unscrew the connector and disconnect the hydraulic clutch actuator rigid pipe.2. Undo the tabs of bush (2a) and partly withdraw together with rigid pipe (2b). 1. Undo the clips (1a), separate the bush (1b) from the rigid pipe (1c) and remove them.

Replace the bush after disassembly.

1. Undo the bolts (1a) and remove clutch hydraulic actuator (1b) complete with seal. Refitting ( Removing ) - Check the condition of the clutch actuator sealing ring and moisten slightly with transmission fluid.- Place the hydraulic clutch actuator in position and secure it tightening the bolts to the recommended torque.

If a new hydraulic clutch actuator is fitted, remove the device used for locking during transport (red bracket).

Component	Fastening	dia	Value (daNm)	Validity
Hydraulic clutch actuator	Bolt	-	0.6 ÷ 1.2	1.3 Multijet 90CV1.9 Multijet

- Refit a new bush in its seat on the gear casing until it can be heard to click into place.

The dog on the bush must align with the seat on the gear casing.

- Refit the rigid pipe in its seat and insert into the bush until it can be heard to click into place.

Check the seal on the rigid pipe and replace if necessary.

- Connect the rigid pipe to the hydraulic clutch actuator and tighten the fitting to the specified torque.

Component	Fastening	dia	Value (daNm)	Validity
Hydraulic clutch actuator rigid pipe	Connector	-	-	1.3 Multijet 90 CV1.9 Multijet

- Refit the clutch hydraulic actuator fitting and secure with the retaining clip.