199000959 - 2125C32 GEARBOX HAND CONTROL LEVER MOUNTING - R.R.

Removing ( Refitting )     Op. 5530B10 BATTERY - R+R     Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R - Position the gear lever in neutral.- Open the upper gearlever gaiter closure.1. Disconnect the gear selector cable.2. Disconnect the gear engagement cable.
1. Open the clips (1a) and release the gear selector and engagement cables (1b) from the mounting bracket.
1. Raise the selection unit until the hole (1a) is aligned with hole (1b), then insert a 5 mm diameter pin (1c) and lock the assembly in this position.
    Op. 1076A48 CATALYTIC CONVERTER HEAT SHIELD - R.R1. Undo the nuts (1a) and the bolt (1b) and remove the gearbox manual control assembly (1c).
1. Undo the clips and remove the cover from the gearbox handlever mount.
1. Disconnect cables (1a), compress clips (1b) and remove the gear selection and engagement cables.
- Use an appropriate protection and pliers to unscrew and remove the gearlever grip. Refitting ( Removing ) - Place the gear selector and engagement cables back in their housings.
Check that the rubber mountings for the gear selector and engagement cables are correctly positioned on the mounting.
- Fasten the gear selector and engagement cables to the support using the clips.- Connect the gear selector and engagement cables to the manual gearbox control lever.- Refit the gearlever mount cover in its seat and secure with clips.- Refit the gearlever mount assembly in its seat, secure by tightening the bolts to the specified torque and insert the gear selection and control cables into the engine compartment.
ComponentFasteningdia  Value (daNm)Validity
Gearbox manual control lever supportBoltM82.2 ÷ 2.71.9 Multijet
    Op. 1076A48 CATALYTIC CONVERTER HEAT SHIELD - R.R- Position the gear selector and engagement cables in the housings in the mounting bracket and secure them using the clips.- Connect the gear selector and engagement cables.- Tighten the gear lever grip using an appropriate protection and grip.- Proceed with the adjustment of the gear selector cable following the instructions given below.1. Lift the inhibiter (1a), turn anticlockwise through 90°, lower until the clip (1b) fits into seat (1c).
1. Prepare the auto-adjustment device (quick adjuster) located on the gear selection cable by pulling the component (1a) backwards and lowering the spring (1b); release the component (1a) to keep the spring (1b) in position.
1. Compress the spring (1a) to release the inhibiter (1b) from the seat (1c) and turn it clockwise through 90°.
- Tighten the gear lever knob.- Extract the locking pin from the gear selector assembly.- Carry out a test engagement of first speed and make sure that the quick adjuster slides along the terminal.    Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R     Op. 5530B10 BATTERY - R+R