G010 NO ACOUSTIC WARNING FOR HANDBRAKE APPLIED WITH VEHICLE MOVING - Fiat - GRANDE PUNTO - eLearn

199000784 - G010 NO ACOUSTIC WARNING FOR HANDBRAKE APPLIED WITH VEHICLE MOVING

With the vehicle moving, if the handbrake is accidentally operated this is not indicated by the acoustic warning

N.B.: The instrument panel node acquires the handbrake switch status and vehicle speed signal from the network. If the handbrake is activated and the vehicle speed is above 4 km/h, an acoustic warning is issued

This function can be enabled/disabled using the MODE +/- buttons in the control panel. Make sure that the function has not been disabled by mistake by the user

0	PRELIMINARY CHECKS	All OK	Problems encountered	Operation
		Results of the tests
	Connect the Examiner Plus or Smart diagnostic equipment and check, in the active diagnosis ambient, that the buzzer is working properly	Move on to Step 1	The buzzer is not working properly	Replace the instrument panel node Op. 5560B10 CONTROL PANEL - R+R
1	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Keeping the Examiner diagnostic equipment connected check, in the parameters ambient, that the handbrake switch status learning is correct	Move on to Step 3	Malfunction in the acquisition of the handbrake switch status	Move on to Step 2
2	ELECTRICAL CONNECTION CHECK	All OK	Problems encountered	Operation
	Check the electrical connections between the handbrake switch and the Body Computer See E4010 INSTRUMENT PANEL Also check that the handbrake switch is not faulty	Move on to Step 3	1. Connections faulty2. Handbrake switch faulty	1. Restore the correct connections See E4010 INSTRUMENT PANEL 2. Replace the handbrake switch Op. 5550D18 HANDBRAKE ON WARNING LIGHT SWITCH - R+R
3	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Connect the Examiner diagnostic equipment and check the following at the body computer node:- that there are no errors at the C-CAN line- that there are no speedometer signal errors	Move on to Step 4	1. Error detected at the C-CAN line2. Error detected at the speedometer signal	1. Continue following the instructions for the diagnostic equipment2. Proceed as instructedSee table K003 SPEEDOMETER NOT WORKING
4	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Keeping the Examiner diagnostic equipment connected, check the following at the instrument panel node:- that there are no errors at the B-CAN line;- that there are no speedometer signal errors	Move on to Step 5	1. Error detected at the B-CAN line2. Error detected at the speedometer signal	1. Continue following the instructions for the diagnostic equipment2. Proceed as instructed in theSee table K003
5	ELECTRICAL CONNECTION CHECK	All OK	Problems encountered	Operation
	Check the electrical connections between the instrument panel and the Body Computer See E4010 INSTRUMENT PANEL	Move on to Step 6	Connections faulty	Restore the correct connections See E4010 INSTRUMENT PANEL
6	CHECK ON CORRECT OPERATION	All OK	Problems encountered	Operation
	Check that the fault is no longer present	End of diagnosis	The fault persists	Replace Body Computer Op. 5505A32 BODY COMPUTER - R.R