| | Results of the tests |
| 1 | PRELIMINARY CHECKS | All OK | Problems encountered | Operation |
|---|
| Connect an EXAMINER and check the following on CAN NETWORK INFORMATION:- No control units inactive- No faulty control units- No control units with faulty CAN line | Move on to Step 2 | 1. Fault on CAN network2. Communication impossible with the Body Computer | 1. Continue following the instructions for the diagnostic equipment2. Move on to Step 8 |
| 2 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|
| Keeping the diagnostic equipment connected, check that there are no CAN faults at the BRAKE NODE | Move on to Step 3 | Fault on C-CAN network | Continue following the instructions for the diagnostic equipment |
| 3 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|
| Using an Examiner check, in Instrument Panel mode, that there are no errors and that the parameters are present. | Move on to Step 4 | Presence of errors | Continue following the instructions on the diagnostic instrument |
| 4 | ELECTRICAL POWER SUPPLY CHECK | All OK | Problems encountered | Operation |
|---|
| Check the electricity supply to the Instrument Panel Node is correct | Move on to Step 5 | Fault in positive electrical supply and/or earth | Replace defective component (in the case of a fuse, find out what caused it to blow). |
| 5 | CHECK ELECTRICAL CONNECTIONS | All OK | Problems encountered | Operation |
|---|
| Check the wiring between the Body Computer and the Instrument Panel. In particular, check that each individual pin is properly connected. | Move on to Step 6 | Electrical connections not operational | Renew the damaged electrical connections |
| 6 | ACTIVE DIAGNOSIS CHECK | All OK | Problems encountered | Operation |
|---|
| With the Examiner in the Instrument Panel Node ambient check that the warning lights are correctly activated in Active Diagnosis. | Move on to Step 7 | The warning lights do not flash | Replace the Instrument Panel Op. 5560B10 CONTROL PANEL - R+R |
| 7 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|
| Using an Examiner check, in Body Computer Node mode, that there are no errors. | Move on to Step 9 | 1. Impossible to connect to the Body Computer control unit.2. Presence of errors | 1. Move on to Step 82. Continue by following the instructions on the diagnostic instrument |
| 8 | ELECTRICAL POWER SUPPLY CHECK | All OK | Problems encountered | Operation |
|---|
| Check the electricity supply to the Body Computer Node is correct. | Move on to Step 9 | Fault in positive electrical supply and/or earth | Replace defective component (in the case of a fuse, find out what caused it to blow). |
| 9 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|
| Use an Examiner to check the possibility of connection to the Body Computer Node | End of diagnosis | Impossible to connect to the Body Computer control unit. | Replace Body Computer Op. 5505A32 BODY COMPUTER - R.R |
