| | Results of the tests |
| 0 | PRELIMINARY CHECKS | All OK | Problems encountered | Operation |
|---|
| Check that the ABS warning light comes on and goes out during the initial test | Move on to Step 1 | The ABS warning light also remains on | Continue as indicated See table K062 ABS AND HANDBRAKE WARNING LIGHTS BOTH ON |
| 1 | ELECTRICAL SYSTEM CHECK | All OK | Problems encountered | Operation |
|---|
| Check the insulation to earth of the wiring between the Handbrake lever switch and the Body Computer | Move on to Step 2 | Wiring not insulated | Restore the correct wiring See E4010 INSTRUMENT PANEL |
| 2 | SWITCH CHECK | All OK | Problems encountered | Operation |
|---|
| Check the condition of the switch on the handbrake lever | Move on to Step 3 | Switch defective | Replace the switch Op. 5550D18 HANDBRAKE ON WARNING LIGHT SWITCH - R+R |
| 3 | ACTIVE DIAGNOSIS CHECK | All OK | Problems encountered | Operation |
|---|
| With the Examiner in the Instrument Panel Node ambient check that the handbrake warning light is correctly activated in Active Diagnosis. | Move on to Step 5 | 1. The handbrake warning light does not flash2. Impossible to connect with the Instrument Panel Node3. Presence of errors | 1. Replace the Instrument Panel2. Move on to Step 43. Continue by following the instructions on the diagnostic instrument |
| 4 | ELECTRICAL POWER SUPPLY CHECK | All OK | Problems encountered | Operation |
|---|
| Check the electricity supply to the Instrument Panel Node is correct. | Move on to Step 5 | Fault in positive electrical supply and/or earth | Replace defective component (in the case of a fuse, find out what caused it to blow) |
| 5 | CHECK ELECTRICAL CONNECTIONS | All OK | Problems encountered | Operation |
|---|
| Check the wiring between the Body Computer and the Instrument Panel. In particular, check that each individual pin is properly connected. | Move on to Step 6 | Electrical connections not operational | Renew the damaged electrical connections |
| 6 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|
| Using the Examiner check, in the Body Computer ambient, that there are no errors and that the parameter specified varies | End of diagnosis | 1. Impossible to connect to the Body Computer control unit.2. Presence of errors3. The parameters do not change | 1. Move on to Step 72. Continue by following the instructions on the diagnostic instrument3. Move on to Step 8 |
| 7 | ELECTRICAL POWER SUPPLY CHECK | All OK | Problems encountered | Operation |
|---|
| Check the electricity supply to the Body Computer Node is correct. | Move on to Step 8 | Fault in positive electrical supply and/or earth | Replace defective component (in the case of a fuse, find out what caused it to blow). |
| 8 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|
| Use an Examiner to check the possibility of connection to the Body Computer Node | End of diagnosis | Impossible to connect to the Body Computer control unit. | Replace Body Computer Op. 5505A32 BODY COMPUTER - R.R |
