| | Results of the tests |
| 0 | PRELIMINARY CHECKS | All OK | Problems encountered | Operation |
|---|
| With the ignition OFF, activate the hazard warning lights and switch them off checking that they come on/go off. With the ignition ON, turn all the functions on and off using the left control panel, namely:- fog lights-rear fog lamps and check that they are activated/deactivated | Move on to Step 1 | 1. The foglamps are not working2. The rear foglamps are not working | 1. Continue as indicated See table I020 FOG LIGHTS NOT WORKING 2. Continue as indicated See table I021 REAR FOG LAMPS NOT WORKING |
| 1 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|
| Using an Examiner check, in Instrument Panel mode, that there are no errors and that the parameters are present. | Move on to Step 2 | Presence of errors | Continue following the instructions on the diagnostic instrument |
| 2 | ELECTRICAL POWER SUPPLY CHECK | All OK | Problems encountered | Operation |
|---|
| Check the electricity supply to the Instrument Panel Node is correct | Move on to Step 3 | Fault in positive electrical supply and/or earth | Replace defective component (in the case of a fuse, find out what caused it to blow) |
| 3 | CHECK ELECTRICAL CONNECTIONS | All OK | Problems encountered | Operation |
|---|
| Check the wiring between the Body Computer and the Instrument Panel. In particular, check that each individual pin is properly connected | Move on to Step 4 | Electrical connections not operational | Renew the damaged electrical connections |
| 4 | ACTIVE DIAGNOSIS CHECK | All OK | Problems encountered | Operation |
|---|
| With the Examiner in Instrument Panel Node mode, check that the warning lights in question are correctly activated in Active Diagnosis. | Move on to Step 5 | The warning lights do not flash | Replace the Instrument Panel Op. 5560B10 CONTROL PANEL - R+R |
| 5 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|
| Using the Examiner check, in the Body Computer Node mode, that there are no errors and that the parameters are present. | Move on to Step 6 | 1. Impossible to connect to the Body Computer control unit.2. Presence of errors3. The parameters do not change | 1. Move on to Step 62. Continue by following the instructions on the diagnostic instrument3. Move on to Step 8 |
| 6 | ELECTRICAL POWER SUPPLY CHECK | All OK | Problems encountered | Operation |
|---|
| Check the electricity supply to the Body Computer Node is correct | Move on to Step 7 | Fault in positive electrical supply and/or earth | Replace defective component (in the case of a fuse, find out what caused it to blow) |
| 7 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|
| Use an Examiner to check the possibility of connection to the Body Computer Node | Move on to Step 8 | Impossible to connect to the Body Computer control unit. | Replace Body Computer Op. 5505A32 BODY COMPUTER - R.R |
| 8 | CHECK ON CORRECT OPERATION | All OK | Problems encountered | Operation |
|---|
| Check that the fault is no longer present | End of diagnosis | The fault persists | Contact technical service for further information on the problem |
