| | Results of the tests |
| 1 | RELAY CHECK | All OK | Problems encountered | Operation |
|---|
| Remove the horn relay feed and check that the horns stop making a sound.Swap the relay for the horns T3 (20A) with the one for the main beam headlamps T2 and check that the horns work normally | Move on to Step 2 | 1. The horns continue to make a sound even without the relay2. The horns continue to sound without being pressed even after the relays have been swapped | 1. Restore the correct electrical connections See E3010 HORNS 2. Restore the relays to their places and move on to Step 3 |
| 2 | RELAY CHECK | All OK | Problems encountered | Operation |
|---|
| Check that the main beam headlamps are working properly.If the result is positive, remove the horn relay feed and check that the contacts do not show signs of oxidation or deformation | End of diagnosis | 1. The main beam headlamps remain on in all conditions2. There are irregularities at the engine compartment junction unit contacts | 1. Replace the main beam headlamp relay (which was originally the one for the horns)2. Renew the contacts. If necessary, replace the engine compartment junction unit Op. 5505A13 ADDITIONAL JUNCTION UNIT IN ENGINE COMPARTMENT - R.R. |
| 3 | HORN ELECTRICAL CHECK | All OK | Problems encountered | Operation |
|---|
| Connect a tester to the horn supply line and check the continuity and the insulation of the line | Move on to Step 4 | Electrical faults: engine compartment junction unit defective | Replace the engine compartment junction unit Op. 5505A13 ADDITIONAL JUNCTION UNIT IN ENGINE COMPARTMENT - R.R. |
| 4 | STEERING COLUMN SWITCH UNIT CHECK | All OK | Problems encountered | Operation |
|---|
| Remove the steering wheel and check that there is nothing preventing the operation of the horn control switch | Move on to Step 5 | Switch stuck in closed position | Replace the steering column switch unit. Op. 5550A10 STALK UNIT ASSEMBLY - R+R |
| 5 | ELECTRICAL CIRCUIT CHECK | All OK | Problems encountered | Operation |
|---|
| The problem is due to the presence of a short circuit in the electrical system.Search for and eliminate this cause See E3010 HORNS | End of diagnosis | The fault persists | Contact technical service for further information on the problem |