| | Results of the tests |
| 1 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|
| Connect the Examiner diagnostic equipment and carry out the active diagnosis for the defective door lock | Move on to Step 2 | The door does not close/open | Move on to Step 3 |
| 2 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|
| Keeping the Examiner diagnostic equipment connected, check:- no control units inactive;- no faulty control units; | Move on to Step 6 | Presence of faults | Continue following the instructions for the diagnostic equipment |
| 3 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|
| Using the Examiner diagnostic equipment, check that the learning of the change of state for the door opening/closing switch is correct | Move on to Step 5 | The signal for the door opening/closing switch status has not been learnt correctly | Move on to Step 4 |
| 4 | ELECTRICAL CIRCUIT CHECK | All OK | Problems encountered | Operation |
|---|
| Check the continuity/insulation of the electrical connection between the defective door lock and the Body Computer See E3040 CENTRAL LOCKING | Move on to Step 6 | Electrical connection broken or not insulated | Restore the electrical connection see wiring diagram See E3040 CENTRAL LOCKING |
| 5 | CHECK ON CORRECT OPERATION | All OK | Problems encountered | Operation |
|---|
| Check that the fault is no longer present | End of diagnosis | Problem persists | Replace the defective door lock:- if it is a front door: Op. 7005N21 FRONT SIDE DOOR LOCK MOTOR/LOCK ASSEMBLEY FOR ONE DOOR, LEFT OR RIGHT - R.R. - if it is a rear door: Op. 7010N21 REAR SIDE DOOR LOCK MOTOR/LOCK ASSEMBLY, LEFT OR RIGHT - R.R |
| 6 | CHECK ON CORRECT OPERATION | All OK | Problems encountered | Operation |
|---|
| Check that the fault is no longer present | End of diagnosis | Problem persists | Replace body computer Op. 5505A32 BODY COMPUTER - R.R |
