199000885 - P011 CENTRAL LOCKING / NOT WORKING WITH REMOTE CONTROL

When the door closing/opening is controlled using the remote control, the central locking does not work.

The Body Computer Node receives the signal from the remote control via the RF aerial. Having received the command, it sends the opening/closing signal to the door actuators and to the luggage compartment actuator.

		Results of the tests
0	PRELIMINARY CHECK	All OK	Problems encountered	Operation
	Activate the closing/opening of the doors using the second remote control that comes with the vehicle	Move on to Step 4	1. Problem persists2. The system works using the second remote control	1. Move on to Step 12. Replace the defective remote control
1	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Connect the Examiner diagnostic equipment to the Body Computer Node and check that there are no errors	Move on to Step 2	Error detected: RF receiver broken	Move on to step 3
2	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Keeping the diagnostic equipment connected to the Body Computer node, check the following in the parameters ambient:- that the remote control is correctly programmed;- the operation of the individual remote control buttons	Move on to Step 5	1. Remote control not properly programmed2. Remote control buttons malfunction	1. Programme the remote control2. Move on to Step 4
3	ELECTRICAL CIRCUIT CHECK	All OK	Problems encountered	Operation
	Check that the RF receiver aerial is not interrupted or incorrectly connected to the Body Computer Node	Move on to Step 5	1. Aerial lead broken.2. Aerial lead connector not correctly connected to the Body Computer Node	1. Restore the continuity/insulation of the aerial lead see wiring diagram    See E3040 CENTRAL LOCKING 2. Connect the aerial lead connector properly to the Body Computer Node
4	REMOTE CONTROL BATTERY CHECK	All OK	Problems encountered	Operation
	Check that the remote control battery is not run down.	Move on to Step 6	Battery run down	Replace the remote control battery
5	CHECK ON CORRECT OPERATION	All OK	Problems encountered	Operation
	Check that the fault is no longer present	End of diagnosis	The fault persists	Replace the remote control and programme the new remote control at the Body Computer Node
6	CHECK ON CORRECT OPERATION	All OK	Problems encountered	Operation
	Check that the fault is no longer present	End of diagnosis	The fault persists	Replace the Body Computer Node    Op. 5505A32 BODY COMPUTER - R.R