| | Results of the tests |
| 1 | FUSE AND RELAY CHECK | All OK | Problems encountered | Operation |
|---|
| Check the condition of the fuses and relaysSee E3045 BOOT AND FUEL FLAP OPENING | Move on to Step 2 | Components faulty | Replace the component (in the case of a fuse, find out what caused it to blow) |
| 2 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|
| Press the button in the dashboard and check that the status of the boot lid opening button varies in the parameters ambient at the Body Computer Node | Move on to Step 4 | 1. Button in dashboard defective2. Wiring broken3. Body Computer defective | 1. Replace the button2. move on to step 33. Replace Body Computer |
| 3 | ELECTRICAL CIRCUIT CHECK | All OK | Problems encountered | Operation |
|---|
| - Check the electrical connection between the button in the dashboard and the body computerSee E3045 - Check the electrical connection between the body computer and the luggage compartment electric lockSee E3045 - Check that the connector is correctly fitted in the electric lock | Move on to Step 4 | 1. Connection broken or not insulated2. Connection broken or not insulated3. Connector in boot electric lock not correctly connected | 1. Restore the continuity/insulation of the electrical connectionSee E3045 2. Restore the continuity/insulation of the electrical connectionSee E3045 3. Connect the electrical connector to the boot lock correctly |
| 4 | BOOT OPENING ACTUATOR CHECK | All OK | Problems encountered | Operation |
|---|
| Check the operation of the boot electric lock | Move on to Step 5 | Electric lock defective | Replace the electric lock Op. 7015B70 TAILGATE LOCK MOTOR - R.R AND CHECK LOCK SUPPLY LINE |
| 5 | CHECK ON OPENING USING THE KEY | All OK | Problems encountered | Operation |
|---|
| Operate the key and check that the boot and the doors open properly | Move on to Step 7 | There is no variation in status | Move on to Step 6 |
| 6 | ELECTRICAL CIRCUIT CHECK | All OK | Problems encountered | Operation |
|---|
| Check the electrical connection between the driver''s central locking and the Body Computer Check the operation of the driver''s side central locking | Move on to Step 7 | 1. Connections broken or not insulated2. Central locking defective3. Body Computer defective | 1. Restore the continuity/insulation of the electrical connectionSee E3045 2. Replace central locking3. Replace the Body Computer Op. 5505A32 BODY COMPUTER - R.R |
| 7 | CHECK ON CORRECT OPERATION | All OK | Problems encountered | Operation |
|---|
| Check that the fault is no longer present | End of diagnosis | The fault persists | Contact technical service for further information on the problem |
