199002697 - 5040BC CLIMATE CONTROL COMPRESSOR LINEAR SENSOR ON/OFF CHECK

Disconnect the electrical connection for the linear sensor [EL_K120].Check that Pin 1 is earthed and Pin 2 is at +5V.Connect a linear potentiometer (end of scale 1 KOhm, previously positioned at around 500 ohm between the centre pin andone of the side ones) to the pins of the linear sensor electrical connector.Turn the ignition key to the ON position.Using a multimeter, check that the voltage between pins 1 and 3 is around 2.5V.Switch on the engine and switch on the air conditioning using the special switch located on the climate control system control unit.The climate control system should come on normally in these circumstances.Alter the potentiometer resistance until the voltage reading on the multimeter between pins 1 and 3 is about 0 V.The air conditioning system should switch off in these conditions because the engine management node receives low circuit pressure information.Alter the potentiometer resistance until the voltage reading on the multimeter between pins 1 and 3 is about 4.6V.The air conditioning system should switch off in these conditions because the engine management node receives high circuit pressure information.