199000513 - 1060F10 FUEL INJECTORS - R.R.

Removing ( Refitting )     Op. 1016A10 SOUND-PROOFING COVER - R.R     Op. 5530B10 BATTERY - R+R     Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R     Op. 1048B27 RIGID PIPE FOR AIR INLET TO THROTTLE BODY - R R    Op. 1060G50 THROTTLE BODY - R.R     Op. 1080C24 E.G.R. SYSTEM SOLENOID - R + R     Op. 1060F36 PIPES (ALL) FROM FUEL MANIFOLD TO INJECTOR - R.R. 1. Manually push the clips (1a) and disconnect the pipe from the injectors to the fuel manifold (1b), injector side.
1. Undo the nuts fixing the injector mounting brackets.2. Position the tool (2a) for extracting the injectors, taking care to position the lifting bracket (2b) under the polygonal area (2c) of the injector.
ToolDescriptionFunctionValidity
1870739000ExtractorRemoving injectors1.3 Multijet1.9 Multijet
If a new injector/new inectors are fitted:- determine the identification code stamped on the top surface;- check, using an Examiner, the the new injector(s) is (are) recognized by the engine management control unit.
3. Position the second tool lifting bracket (3a) under the injector securing bracket (3b).4. Tighten the tool nut (4a) and remove the injector assembly (4b).- Repeat the operation for the remaining injectors.
Refitting ( Removing ) - Place the injectors (1a) in their seats complete with brackets and fasten them tightening the nuts to the recommended torque.
ComponentFasteningdia  Value (daNm)Validity
Injector brackets NutM82.7 ÷ 3.31.9 Multijet
- Connect the pipe from the injectors to the fuel recovery manifold to the injectors and push home until the clips click into place.    Op. 1060F36 PIPES (ALL) FROM FUEL MANIFOLD TO INJECTOR - R.R.     Op. 1080C24 E.G.R. SYSTEM SOLENOID - R + R     Op. 1060G50 THROTTLE BODY - R.R     Op. 1048B27 RIGID PIPE FOR AIR INLET TO THROTTLE BODY - R R    Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R     Op. 5530B10 BATTERY - R+R     Op. 1016A10 SOUND-PROOFING COVER - R.R