| STEP | CHECK TO BE PERFORMED | RESOLUTION IF THE CHECK IS NOT OK |
|---|
| 1 | Turn the ignition key OFF.Disconnect the wiring harness connector from Body Computer connector ATurn the ignition key ON.Disconnect all the electrical appliances and reverse.Measure the voltage between Pin 1 of the wiring connector (wiring side) of the Body Computer See M001 BODY COMPUTER and Earth, checking it is less than 0.3 V.Move on to Step 4 | Move on to Step 2 |
| 2 | Turn the ignition key OFF.Disconnect the wiring harness connector from the reversing light switch.Turn the ignition key ON.Measure the voltage between Pin 1 of the wiring connector (wiring side) of the Body Computer See M001 BODY COMPUTER and Earth, checking it is greater than 0.3 V | Replace the reversing switch Op. 5550D22 REVERSING LIGHT SWITCH - R+R |
| 3 | Repair or replace the electrical wiring between the reversing switch, reversing light and Body Computer See E2022 REVERSING LIGHTS The test can be considered over | |
| 4 | Engage reverse gear.Measure the voltage between Pin 1 of the wiring connector (wiring side) of the Body Computer See M001 BODY COMPUTER and Earth, checking it is less than 11 V | Replace Body Computer Op. 5505A32 BODY COMPUTER - R.R |
| 5 | Turn the ignition key OFF.Remove fuse F59 (second from the left on the second row from the bottom) in the engine compartment junction unit and check it has not blown.Move on to Step 7 | Move on to Step 6 |
| 6 | Disconnect the wiring harness connector from the reversing light switch.Turn the ignition key ON.Fit a new fuse F59 and check it does not blow.The test can be considered over | Repair or replace the electrical wiring between the reversing switch and the engine compartment junction unit See E2022 REVERSING LIGHTS |
| 7 | Turn the ignition key OFF.Connect a shunt cable with a fuse between switch Pin 2 (wiring side) See I020 REVERSING LIGHTS SWITCH (GEARBOX BRIDGE)and the battery positive and check that the fuse of the shunt connection does not cut out.Move on to Step 9 | Move on to Step 8 |
| 8 | Disconnect the wiring harness connector from the reversing tail-light.Fit a new fuse in the shunt connection and check it does not cut out.Move on to Step 3 | Replace the reversing light Op. 5550D24 REVERSING LIGHT - R+R |
| 9 | Reconnect the wiring harness connector to Body Computer connector A and check that the shunt connection fuse does not cut out. | Replace Body Computer Op. 5505A32 BODY COMPUTER - R.R |
| 10 | Replace the reversing switch Op. 5550D22 REVERSING LIGHT SWITCH - R+R | |