199002976 - 1060GF SUPERCHARGING PRESSURE CHECK

STEPCHECK TO BE PERFORMEDRESOLUTION IF THE CHECK IS NOT OK
1Turn the ignition key ON.With the engine off and all users off, the Target Turbo Pressure must be within a range between 0.9 and 1.2 bars.Under the same conditions, the Turbo Pressure reading must be in a range between 0.9 and 1.2 bars and in any case must be approximately equal to the external pressureMove on to Step 4
2With the engine idling and accelerator pedal not operated, the Target Turbo Pressure must be within a range between 0.9 and 1.2 bars.Under the same conditions, the Measured Turbo Pressure must be within a range between 0.9 and 1.2 bars.Move on to Step 4
3With the accelerator pedal slightly operated and engine speed equal to 3000 rpm, the Target Turbo Pressure must be within a range between 10 and 23 bars.Under the same conditions, the Measured Turbo Pressure must be within a range between 10 and 23 bars.The test can be considered overMove on to Step 4
4Turn the ignition key OFF.Disconnect the wiring harness connector from the fuel pressure sensor.    See K083 FUEL PRESSURE SENSOR Turn the ignition key ON.Measure the voltage between regulator (wiring side) Pins 3 and 1Ensure that it is in a range between 4.8 and 5.2 V.Move on to Step 6
5If faults are present, repair or if necessary replace the electrical wiring between the engine control unit and the sensor    See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT The test can be considered overReplace the engine management control unit    Op. 1060G80 DIESEL ELECTRONIC INJECTION CONTROL UNIT - R.R
6Measure the voltage between sensor Pin 3 (wiring side)    See K083 FUEL PRESSURE SENSOR and earth. Ensure that it is in a range between 4.9 and 6.0 V.Move on to Step 5
7With the tester in Parameter modedisplay the Measured Turbo Pressure Ensure it is in a range between 4.8 and 5.2 VReplace the engine management control unit    Op. 1060G80 DIESEL ELECTRONIC INJECTION CONTROL UNIT - R.R
8Connect a shunt cable with a fuse between sensor Pin 3 (wiring side)    See K083 FUEL PRESSURE SENSOR and the earth.Check that now the Measured Turbo Pressure is less than 0.3 VReplace the engine management control unit    Op. 1060G80 DIESEL ELECTRONIC INJECTION CONTROL UNIT - R.R
9Replace the fuel pressure sensor    Op. 1060G28 FUEL PRESSURE SENSOR ON FUEL MANIFOLD TO INJECTORS - R.R