199003078 - P0335 Rpm sensor

This error is detected if the variation in position of the crankshaft is not within the acceptable range of values or cannot be learnt (with signal not valid detail) or if the control module recognizes the camshaft impulses but not the crankshaft impulses (with general electrical fault detail). As a result, the engine is switched off.
Test results
0PRELIMINARY CHECKSAll OKProblems encounteredOperation
Check that the error detail is not invalid signalMove on to Step 3The detail is invalid signalMove on to Step 1
1ERROR DELETIONAll OKProblems encounteredOperation
Cancel the errors present and turn the ignition key OFF.Wait for the engine management control unit to switch off (min. 20 secs.).
The main relay is switched off. If the engine is very hot, the fans remain on after the ignition is switched off. In this case, the control unit switches off automatically 10 secs after the fans are switched off.
Move on to Step 2
2ERRORS CHECKAll OKProblems encounteredOperation
Drive the vehicle in different driving conditions (engine speed and engine load) for a long stretch.Listen out for any unusual noises and other system irregularities.At the end of the road test, check that none of the following errors is present using the diagnostic equipment:- P0335 - Engine rpm sensor with detail "signal not valid"- P0606 - Control unit broken (microprocessor)- P1618 – Control unit broken (HW CY940)End of diagnosisThe engine is not running smoothlyProceed as instructed in the    See table D003 ENGINE NOT RUNNING SMOOTHLY / (IRREGULAR OPERATION)
The engine is losing powerProceed as instructed in the    See table D004 ENGINE NOT RUNNING SMOOTHLY
The engine does not produce maximum performanceProceed as instructed in the    See table D005 ENGINE DOES NOT PRODUCE BEST PERFORMANCE
The engine response is poorProceed as instructed in the    See table D016 POOR ENGINE RESPONSE
There is engine knockProceed as instructed in the    See table S003 ENGINE KNOCKING
Error P0335 is presentProceed as instructed in the    See Test 1060GI CHECK ENGINE SPEED
Error P0606 is presentProceed as instructed in the    See Test 1060GK CHECK CONTROL UNIT SOFTWARE AND HARDWARE
Error P1618 is presentProceed as instructed in the    See Test 1060GL CHECK OPERATION OF MAIN ENGINE CONTROL UNIT RELAY
3RPM SENSOR OPERATION CHECKAll OKProblems encounteredOperation
Check correct operation of the rpm sensor by carrying out the    See Test 1060GI CHECK ENGINE SPEEDEnd of diagnosis