199003085 - P0606 Control Unit faulty (Microprocessor)

This error is detected if the control unit recognizes a malfunction in the circuit through an internal logic evaluation.
Test results
0PRELIMINARY CHECKSAll OKProblems encounteredOperation
Select the following system on the diagnostic equipment: Bosch diesel injection control unit EDC16C39 CF4/EOBD CAN (EP engine 1.9).Cancel the errors present and turn the ignition key OFF.Wait for the engine management control unit to switch off (min. 20 secs.).
The main relay is switched off. If the engine is very hot, the fans remain on after the ignition is switched off. In this case, the control unit switches off automatically 10 secs after the fans are switched off.
Move on to Step 1
1ERRORS CHECKAll OKProblems encounteredOperation
Drive the vehicle in different driving conditions (engine speed and engine load) for a long stretch.Listen out for any unusual noises and other system irregularities.At the end of the road test, check that none of the following errors is present using the diagnostic equipment:- P0335 with "Signal invalid" detail- P0606- P1618End of diagnosisThe engine is not running smoothlyProceed as instructed in the    See table D003 ENGINE NOT RUNNING SMOOTHLY / (IRREGULAR OPERATION)
The engine is losing powerProceed as instructed in the    See table D004 ENGINE NOT RUNNING SMOOTHLY
The engine does not produce maximum performanceProceed as instructed in the    See table D005 ENGINE DOES NOT PRODUCE BEST PERFORMANCE
The engine response is poorProceed as instructed in the    See table D016 POOR ENGINE RESPONSE
There is engine knockProceed as instructed in the    See table S003 ENGINE KNOCKING
Error P0335 is presentProceed as instructed in the    See Test 1060GI CHECK ENGINE SPEED
Error P0606 is presentProceed as instructed in the    See Test 1060GK CHECK CONTROL UNIT SOFTWARE AND HARDWARE
Error P1618 is presentProceed as instructed in the    See Test 1060GL CHECK OPERATION OF MAIN ENGINE CONTROL UNIT RELAY