199003113 - P2620 Motorised throttle (feedback)

This error is detected if the control unit recognizes a malfunction in the circuit through an internal logic evaluation: short circuit to earth/positive or break in the connecting circuit at Pin 59 of the junction unit.
Test results
1VISUAL INSPECTION OF CONNECTIONSAll OKProblems encounteredOperation
Disconnect the throttle casing actuator cable loom connector on the engine management control unit side and check that the pins are intact and correctly positioned.Also check that there are no signs of oxidation, burning or the presence of waterMove on to Step 2The wiring is faultyRestore or, if necessary, replace the faulty wiring
2PWM SIGNAL CHECKAll OKProblems encounteredOperation
Connect a T bridge between the motor wiring and the throttle casing actuator.Using the diagnostic equipment in digital multimeter mode, check that at Pin 4 of the actuator    See N075 BUILT-IN THROTTLE BODY ACTUATORthere is a feedback signalMove on to Step 3There is not is a feedback signalReplace the throttle body    Op. 1060G50 THROTTLE BODY - R.R
3CHECK ON THROTTLE CASING OPERATIONAll OKProblems encounteredOperation
Check that the integrated throttle casing actuator is working properly by carrying out the    See Test 1060GO INTEGRATED THROTTLE BODY OPERATION CHECKEnd of diagnosis--