199000423 - 1016C10 SINGLE CYLINDER HEAD - R.R. AND REPLACE GASKET

Removing ( Refitting )     Op. 1048A32 HOSE FROM AIR FILTER TO INTAKE MANIFOLD - R + R    Op. 1048A10 AIR FILTER ASSEMBLY - R.R.     Op. 1056B60 SINGLE FUEL MANIFOLD PIPE, WITH INJECTORS - R.R.     Op. 5520B10 STARTER MOTOR - R+R     Op. 1072B50 AIR CHAMBER - R.R.    Op. 1032B10 TOOTHED TIMING BELT - R + R FOR TIMING ADJUSTMENT OR REPLACEMENT     Op. 1016B12 SINGLE CAMSHAFT HOUSING - R.R. WITH TIMING BELT REMOVED - REPLACE GASKET    Op. 1072C44 EXHAUST MANIFOLD HEAT SHIELD - R+R     Op. 1072C16 EXHAUST MANIFOLD WITH CATALYTIC CONVERTER - R.R.     Op. 0010T20 ENGINE COOLANT - CHANGE 1. Undo the bolt (1a) and remove the timing belt inner guard (1b). 1. Disconnect the electrical connection for the engine coolant temperature sensor.

	Description	Connector
3	Engine coolant temperature sensor/sender unit	See K036 ENGINE COOLANT TEMPERATURE SENSOR/SENDER UNIT

2. Loosen the band and disconnect the engine coolant supply pipe to the heater, thermostat side.3. Loosen the band and disconnect the radiator coolant supply hose, thermostat side.4. Disconnect the degassing pipe rapid connector from the thermostat. 1. Undo the bolts (1a) and remove the cylinder head (1b).2. Remove the cylinder head gasket. Refitting ( Removing ) - Fit a new cylinder head gasket on the cylinder block.- Position the cylinder head on the crankcase by aligning the locating dowels.1. Tighten the bolts securing the cylinder head to the recommended torque.

Follow the order shown in the diagram for each tightening sequence.

Component	Fastening	dia	Value (daNm)	Validity
Cylinder head	Bolt	M9	3 + 90° + 90°	1.4 16v

- Connect the degassing pipe rapid connector to the thermostat.- Connect the radiator engine coolant supply hose, thermostat side, and secure it using the band.- Connect the engine coolant supply pipe to the heater, thermostat side, and secure it using the band.- Connect the electrical connection for the engine coolant temperature sensor.- Place the timing belt inner guard in its housing and secure it using the bolt.    Op. 1072C16 EXHAUST MANIFOLD WITH CATALYTIC CONVERTER - R.R.     Op. 1072C44 EXHAUST MANIFOLD HEAT SHIELD - R+R     Op. 1016B12 SINGLE CAMSHAFT HOUSING - R.R. WITH TIMING BELT REMOVED - REPLACE GASKET    Op. 1032B10 TOOTHED TIMING BELT - R + R FOR TIMING ADJUSTMENT OR REPLACEMENT     Op. 1072B50 AIR CHAMBER - R.R.    Op. 5520B10 STARTER MOTOR - R+R     Op. 1056B60 SINGLE FUEL MANIFOLD PIPE, WITH INJECTORS - R.R.     Op. 1048A10 AIR FILTER ASSEMBLY - R.R.     Op. 1048A32 HOSE FROM AIR FILTER TO INTAKE MANIFOLD - R + R    Op. 0010T20 ENGINE COOLANT - CHANGE