199000200 - 7005E50 FRONT SIDE DOOR PILLAR TRIM (ONE) LH OR RH - R.R.
 Removing
		(
		Refitting
Removing
		(
		Refitting )
	    Op. 7005M14 SWITCH UNIT ON DRIVER'S FRONT DOOR - R.R.    Op. 7040E24 LOWER COURTESY LIGHT IN DOOR PANEL - R+R     Op. 7005E10  FRONT SIDE DOOR INTERIOR PANEL - R.R.     Op. 7005D26  FRONT SIDE DOOR DESCENDING WINDOW GLASS SCRAPER (OUTER) (ONE), LEFT OR RIGHT- R.R     Op. 7005D18  FRONT SIDE DOOR DESCENDING WINDOW GLASS CHANNEL (ONE), LEFT OR RIGHT - R.R 1. Release the retainers (1c) and (1d) in the area of the pillar trim to be replaced (1a) or (1b), then move the weatherstrip (1e).2. Heat the trim (1a) or (1b) being removed using hot air, then remove it.
		)
	    Op. 7005M14 SWITCH UNIT ON DRIVER'S FRONT DOOR - R.R.    Op. 7040E24 LOWER COURTESY LIGHT IN DOOR PANEL - R+R     Op. 7005E10  FRONT SIDE DOOR INTERIOR PANEL - R.R.     Op. 7005D26  FRONT SIDE DOOR DESCENDING WINDOW GLASS SCRAPER (OUTER) (ONE), LEFT OR RIGHT- R.R     Op. 7005D18  FRONT SIDE DOOR DESCENDING WINDOW GLASS CHANNEL (ONE), LEFT OR RIGHT - R.R 1. Release the retainers (1c) and (1d) in the area of the pillar trim to be replaced (1a) or (1b), then move the weatherstrip (1e).2. Heat the trim (1a) or (1b) being removed using hot air, then remove it.
 Refitting
		(
		Removing
Refitting
		(
		Removing )
	- Use a new pillar trim.1. Clean any residues of adhesive from the area where the pillar trim is fitted using heptane.2. The temperature of the area (2a) where the trim is fitted should be at least 18 °C.The temperature of the trim (2b) to be fitted should be between 30 and 40 °C.3. Stick the pillar trim (2b) starting from one end and gradually removing the film (3b) protecting the adhesive surface.
		)
	- Use a new pillar trim.1. Clean any residues of adhesive from the area where the pillar trim is fitted using heptane.2. The temperature of the area (2a) where the trim is fitted should be at least 18 °C.The temperature of the trim (2b) to be fitted should be between 30 and 40 °C.3. Stick the pillar trim (2b) starting from one end and gradually removing the film (3b) protecting the adhesive surface.|  | Do not touch the adhesive surface of the trim with your fingers. | 

