199000959 - 2125C32 GEARBOX HAND CONTROL LEVER MOUNTING - R.R.
Removing
(
Refitting
)
Op. 1076A56 EXHAUST PIPE INTERMEDIATE HEAT SHIELD R R Op. 4410D17 REINFORCEMENT FOR FRONT SUSPENSION CROSSMEMBER - R.R.- Position the gear lever in neutral.- Open the upper gear lever boot closure.1. Undo the nuts (1a) and the bolt (1b) and disconnect the exhaust pipe from the catalytic converter; keep the gasket.- Disconnect the exhaust pipe from the flexible mountings, move it aside and secure it appropriately.
Refitting
(
Removing
)
- Refit the gear lever grip in its housing.- Working in the engine compartment, introduce the two quick-fits for the hoses in the openings in the bracket keeping the cursors retracted and inserting them fully into the seats using manual pressure until they are attached.Release the cursors.- Using manual pressure, connect the ends of the gear selection and engagement cables to the ball joints for the levers on the gearbox.- Fit the cover and secure it using the clips.- Release the exhaust pipe from the temporary fastening and connect it to the mounting bracket using the flexible mountings.- Place the exhaust pipe and catalytic converter gasket in its housing.- Connect the exhaust pipe to the catalytic converter and secure by tightening the nuts to the specified torque.| Component | Fastening | dia | Value (daNm) | Validity |
|---|---|---|---|---|
| Flange connecting catalyzer to exhaust pipe | Nut | M8 | 2.5 | 1.2 8v1.4 8v1.4 16v1.3 Multijet |
| Component | Fastening | dia | Value (daNm) | Validity |
|---|---|---|---|---|
| Exhaust pipe to mounting bracket collar | Bolt | M8 | 2.2 ÷ 2.7 | 1.2 8v1.4 8v1.4 16v1.3 Multijet |