199002948 - B010 ENGINE DOES NOT START (UNDER ANY CIRCUMSTANCES)

The starter motor does not work.

		Test results
1	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Connect the diagnostic equipment and check "The list of faulty control units" by going to "Other Systems", "CAN Information".	Move on to Step 2	Faults at the Body Computer Node.	Move on to Step 7
			Faults at the Engine Management Node.	Move on to Step 2
			Errors present at the Electric Steering Node.	Continue by following the instructions on the diagnostic instrument.
			Presence of errors at the Instrument Panel Node.	Continue by following the instructions on the diagnostic instrument.
			Presence of errors at the Brake Node.	Continue by following the instructions on the diagnostic instrument.
2	ENGINE COMPARTMENT FUSE JUNCTION UNIT CHECK	All OK	Problems encountered	Operation
	Check for the presence of blown fuses in the engine compartment junction unit	Move on to Step 3	Fuses blown.	Replace the blown fuses (identifying the cause of the problem).
3	CHECK ON CORRECT OPERATION OF RELAYS	All OK	Problems encountered	Operation
	Check that the main relay and the pump relay are working properly.	Move on to Step 4	Relays not working properly.	Replace the relays that are not working.
4	CHECK ON ENGINE MANAGEMENT CONTROL UNIT POWER SUPPLY AND EARTH	All OK	Problems encountered	Operation
	Check that the engine management control unit power supply and earth are correct.	Move on to Step 5	Power supply not correct.	Restore the correct power supply    See E5030 PETROL ENGINES ELECTRONIC MANAGEMENT
			Earth not correct.	Move on to Step 5.
5	CHECK ON CORRECT CONNECTION TO EARTH OF ENGINE MANAGEMENT CONTROL UNIT FRAME	All OK	Problems encountered	Operation
	Check that the engine management control unit frame is correctly earthed.	Move on to Step 6	Earth connection incorrect.	Restore the correct earth connection for the engine management control unit frame.
6	CHECK CONTINUITY AND INSULATION OF CAN	All OK	Problems encountered	Operation
	Check that the continuity and insulation of the CAN is correct    See E1050 CAN CONNECTION LINES	Move on to Step 7	CAN continuity not correct.	Restore the correct continuity    See E1050 CAN CONNECTION LINES
			Insulation not correct.	Restore the correct insulation.
7	BODY COMPUTER POWER SUPPLY CHECK	All OK	Problems encountered	Operation
	Check that the Body Computer power supply is correct and that the connectors are correctly fitted.	Move on to Step 8	Body Computer power supply incorrect.	Restore the correct Body Computer power supply    See E1010 POWER SUPPLY
			Connectors not correctly fitted at the Body Computer.	Refit the connectors correctly.
8	REPLACE THE ENGINE MANAGEMENT CONTROL UNIT	All OK	Problems encountered	Operation
	Replace the engine management control unit    Op. 1056B82 INJECTION/IGNITION SYSTEM E.C.U. (ONE) - R + R	Move on to Step 9
9	CORRECT OPERATION CHECK	All OK	Problems encountered	Operation
	Check that it is working properly.	End of diagnosis	The fault persists.	Replace Body Computer    Op. 5505A32 BODY COMPUTER - R.R