199002758 - 4420D48 REAR SUSPENSION CROSSMEMBER/AXLE BUSHES - REPLACE

Removing ( Refitting )     Op. 7040L22 REAR COVER ON TUNNEL - R.R.    Op. 4450B13 REAR WHEELS (TWO) - R.R     Op. 4420D10 REAR SUSPENSION AXLE - R+R INCLUDES BLEEDING - Refer to    Op. 4420D20 REAR SUSPENSION AXLE - REPLACE - INCLUDES R+R, CHECK, PARTS TRANSFER AND BLEEDING - CHECK WHEEL GEOMETRY SEPARATELY 1. Fit the tool (1a) as illustrated and remove the bush (1b).
ToolDescriptionFunctionValidity
2000025800Extractor/ Fitting toolRemoving-refitting securing bush to the rear axle support
- Proceed in the same way for the bush on the right side. Refitting ( Removing )
- Avoid fitting the bushes at low temperatures (e.g.: outdoor workshop warehouse).- It is advisable to fit the bushes at a low fitting speed, max. 10 mm per second.
- Follow the instructions below for fitting the bushes.1. The slots (1a) in the bush should be aligned with the welding joining the two track control arm half casings (1b).2. The projection in the middle of the bush should be facing downwards for the left track control arm and upwards for the right one.
1. Place the bush (1a) in position as described previously and fit it using the tool (1b).
ToolDescriptionFunctionValidity
2000025800Extractor/ Fitting toolRemoving-refitting securing bush to the rear axle support
- Proceed in the same way for the bush on the right side.- Refer to    Op. 4420D20 REAR SUSPENSION AXLE - REPLACE - INCLUDES R+R, CHECK, PARTS TRANSFER AND BLEEDING - CHECK WHEEL GEOMETRY SEPARATELY     Op. 4420D10 REAR SUSPENSION AXLE - R+R INCLUDES BLEEDING     Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY     Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR     Op. 4450B13 REAR WHEELS (TWO) - R.R     Op. 3380A04 HANDBRAKE - ADJUST TRAVEL     Op. 7040L22 REAR COVER ON TUNNEL - R.R.