199000064 - 5040A40 AIR CONDITIONING CONDENSER - R+R

Removing ( Refitting )

Follow the recommended safety instructions.    Op. 5040 AIR CONDITIONING CASING AND COMPONENTS

- Position the vehicle on a lift.- Drain the coolant.    Op. 0010T84 COOLANT FOR AIR CONDITIONING SYSTEM - DEHYDRATE AND REPRESSURIZE     Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.     Op. 1088B26 AIR DUCT ON RADIANT MASS - R.R.1. Undo the bolt (1a) and disconnect the pipe connectors (1b) and (1c) from the condenser (1d).

Seal the connectors that have been disconnected using suitable plugs to prevent dampness and impurities from entering the system.

2. Undo the bolts (2b) and remove the condenser (2a) and drier filter.

The drier filter cannot be separated from the condenser.

Refitting ( Removing ) - Check that the condenser is intact and does not show signs of damage or deposits of dirt on the finned surface.1. Place the condenser (1a) in position and tighten the bolts (1b).2. Connect the connectors (2a) for the pipes to the condenser and tighten the bolt (2b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Pipe connector on condenser	Bolt	M8	1.8 ÷ 2.2

Replace the O-rings on the connectors. Only use green coloured seals that are resistant to R134a coolant. Lubricate the connector threads using anti-freeze.

    Op. 1088B26 AIR DUCT ON RADIANT MASS - R.R.    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R. - Repressurize the coolant.    Op. 0010T84 COOLANT FOR AIR CONDITIONING SYSTEM - DEHYDRATE AND REPRESSURIZE