199000120 - 5540B23 MAIN/DIPPED BEAM HEADLAMP OR SIDE LIGHT OR FOG LIGHT OR DIRECTION INDICATOR FOR ONE LH OR RH HEADLAMP/LIGHT CLUSTER - R.R

Removing ( Refitting ) - Proceed as follows for the left headlamp high/low beam bulb.- Open the bonnet.1. Release anchorage (1a) from fitting (1b) of the reservoir containing the washer fluid from clip (1c).2. Withdraw fitting (2a) of the reservoir from its seat (2b). 1. Remove the press-fitted rubber cover in the arrowed direction. 1. Disconnect the central electrical connector.2. Release the bulb retaining clip. 1. Extract the bulb.

If the bulb is working properly, avoid touching it with your hands. If this does happen, clean the bulb with alcohol.

- Proceed as follows for the right headlamp high/low beam bulb.- Open the bonnet.1. Remove the press-fitted rubber cover in the arrowed direction. 1. Disconnect the central electrical connector.2. Release the bulb retaining clip. 1. Extract the bulb.

If the bulb is working properly, avoid touching it with your hands. If this does happen, clean the bulb with alcohol.

Refitting ( Removing ) - Check the condition of the bulb and make sure that it is clean.

Avoid touching the bulb with your hands. If this does happen, clean the bulb with alcohol.

- Repositon the bulb correctly.- Attach the retaining spring.- Connect the electrical connection.- Position the rubber cover.- If removed previously, position the washer fluid reservoir fitting and do up the anchorage.- Check that the bulb is working.- Close the bonnet.