199000264 - 7025A23 DECORATIVE BONNET TRIM (ONE), LEFT OR RIGHT (WITH WINDSCREEN WASHER JETS) - R.R.

Removing ( Refitting ) - Proceed as follows for the left decorative trim.- Open the bonnet.1. Disconnect pipe (1a) from the three-way connector (1b).2. Undo the nut.
- Close the bonnet.1. Release the retainers using the special tool.
ToolDescriptionFunctionValidity
1878077000KnifeRetainer removal
2. Withdraw the left decorative trim (2a) with washer jet and pipe from right decorative trim (2b) and remove.
- If necessary, remove the washer jet pipe and the jet.    Op. 5050B14 PIPES AND CONNECTORS FOR FRONT WINDSCREEN WASHER. - R.R.    Op. 5050B10 FRONT WINDSCREEN WASHER JETS - R+R CLEAN AND/OR POSITION - Proceed as follows for the right decorative trim.- Open the bonnet lid.1. Disconnect pipe (1a) from the three-way connector (1b).2. Release the pipe from the retainers.
1. Undo the nut.
- Close the bonnet.1. Release the retainers using the special tool.
ToolDescriptionFunctionValidity
1878077000KnifeRetainer removal
2. Withdraw the right decorative trim (2a) with washer jet and pipe from left decorative trim (2b) and remove.
- If necessary, remove the washer jet pipe and the jet.    Op. 5050B14 PIPES AND CONNECTORS FOR FRONT WINDSCREEN WASHER. - R.R.    Op. 5050B10 FRONT WINDSCREEN WASHER JETS - R+R CLEAN AND/OR POSITION Refitting ( Removing ) - Check that the decorative trim is not damaged.- If removed previously, fit the washer jet and pipe.    Op. 5050B10 FRONT WINDSCREEN WASHER JETS - R+R CLEAN AND/OR POSITION     Op. 5050B14 PIPES AND CONNECTORS FOR FRONT WINDSCREEN WASHER. - R.R.1. Refit the decorative trim removed, checking that the end of the left trim (1a) is properly fitted in seat (1b) on the end of the right trim (1c).
- Attach the decorative trim retainers.- Open the bonnet lid and tighten the nut.- Connect the pipe to the three-way connector.- Only on the right side, connect the pipe to the retainers.- Close the bonnet.- Check that the windscreen washer jets are working.