199000574 - 1084B18 ENGINE OIL PUMP, REMOVED - CHECK AT BENCH

Removing ( Refitting ) 1. Undo the bolts (1a) and remove the intake (1b).2. Remove the seal.3. Undo the bolts (3a) and remove the oil pump cover (3b).4. Remove the driven gear.5. Remove the drive gear.6. Undo the cap (6a) and release the oil pressure relief valve (6b). - Remove the crankshaft front oil seal Refitting ( Removing ) 1. Check that the radial clearance between the driven gear and the pump casing is within the recommended limits.

Measurement	Value	Validity
Radial clearance between driven gear and pump casing (mm)	0.100 ÷ 0.210	1.4 16v

1. Check that the endfloat between the top of the gears and the oil pump cover support plane is within the recommended values.

Measurement	Value	Validity
Endfloat between the pump casing support plane and the top of the gears (mm)	0.025 ÷ 0.070	1.4 16v1.9 Multijet

- Check that the height of the pressure relief valve spring is within the recommended values.

Measurement	Value	Validity
Height of engine oil pressure limit valve spring under load of 11.73 - 12.51 daN (mm)	35.0	1.4 16v

- Place the oil pressure relief valve in position and secure it using the cap.- Place the drive gear and the driven gear in position.- Place the oil pump cover in position and secure it by tightening the bolts to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Engine oil pump cover	Bolt	M6	0.7	1.4 16v

Manually rotate the gears to check that they do not stick.

- Position the intake duct complete with gasket in its housing and secure it using the bolts.