199002321 - 0010T20 ENGINE COOLANT - CHANGE

- Position the vehicle on a lift.    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R. Procedure for draining the circuit.- With the engine cold, undo the engine coolant supply reservoir cap.
Do not remove the tank cap when the engine is warm as there is a risk of scalding.
1. Open the radiator coolant drainage tap.
Collect the coolant in a suitable container.
Procedure for refilling the circuit.    Op. 1048A23 COLD AIR INTAKE FOR AIR FILTER - R.R - Close the tap on the radiator used for draining the circuit.1. Open the bleed valve on the top right part of the radiator.
1. Introduce the recommended fluid via the filler, keeping the level above the MAX reference on the reservoir as illustrated until fluid comes out of the bleed valve.
ComponentTypeDescriptionClassificationQty.Validity
ENGINE COOLING CIRCUITFluid [I]PARAFLU UPCUNA NC 596-16 - ASTM D 33065.271.2 8v1.4 8v1.4 16v1.4 16v TJet
- Close the bleed valve as soon as the fluid comes out.- Start up the engine and let it idle for about 2 minutes.- At the same time top up the fluid, if necessary, to the MAX reference.- Tighten the plug on the reservoir fitting.- Start the engine and remove the air from the circuit by pumping the accelerator regularly and gradually (every 30 secs) up to a speed of around 3000 rpm. This operation should be carried out until the thermostat opens and the fan switches on and off at least 3 times. During this operation keep the climate control system switched off to prevent the fan from coming on for reasons unconnected to the heating of the coolant. If there is a noticeable drop in the level (below the MIN reference) during this stage, let the engine idle and open the cap very carefully, topping up the fluid to the MAX level, then close the cap fully and remove all the air from the system.- Stop the engine and wait until the circuit has cooled down sufficiently.- Check whether the fluid in the tank needs topping up to the MAX level.- At the end of the above operations, make sure that the amount of fluid introduced into the system is at least equal to the amount collected during the draining stage.