199002482 - 7055A10 MOULDING ON ROOF PANEL (ONE), LEFT OR RIGHT - R.R.
Removing
(
Refitting
)
- For vehicles without sliding roof, proceed as follows.1. Use a plastic spatula to raise one end (1a) of the moulding by releasing from its adhesive retainer (1b).2. Fully remove moulding (2a) by undoing side retainers (2b) and the other adhesive retainer at the end.
- For vehicles with sliding roof, proceed as follows.1. Using a plastic blade, remove the moulding (1a), releasing retainers (1b).
Refitting
(
Removing
)
- Check that the moulding is not damaged.- For vehicles without sliding roof, proceed as follows.1. Clean area (1a) where adhesive pads (1b) are anchored with heptane.2. Remove adhesive pad protections (1c) and immediately fit moulding (2b) in place, attaching the adhesive pads and side retainers.3. Press hard on thethe moulding over the adhesive pads for a few seconds.- Check that the moulding is correctly positioned.
- For vehicles with sliding roof, proceed as follows.- Position the moulding and attach the retainers.- Check that the moulding is correctly positioned.
Removing
(
Refitting
)
- For vehicles without sliding roof, proceed as follows.1. Use a plastic spatula to raise one end (1a) of the moulding by releasing from its adhesive retainer (1b).2. Fully remove moulding (2a) by undoing side retainers (2b) and the other adhesive retainer at the end.
