199002902 - B0107 Passenger pretens. resist.

To apply this procedure, the following must be borne in mind:1 - Measurements cannot be taken on the Air Bag wiring.2 - The system fault diagnosis is started leaving the vehicle charges connected.3- The fault should be "Present" or "Present Intermittently" and not "Intermittent". If the fault is Intermittent then the Procedure is not applicable; proceed with an accurate check on the line where the fault was signalled.4 - Not all the simulation sensors are available (e.g. side impact sensors).

The airbag fault warning light is controlled by a dedicated connection to the airbag control unit Instrument Panel Node.

The Air Bag wiring is a safety component. If there are problems with the cables or the connectors then the wiring should be replaced in one piece.

		Test results
1	ELECTRICAL CONNECTION CHECK	All OK	Problems encountered	Operation
	Turn the ignition key OFF. Check the connector on the control unit is correctly connected    See E7030 AIRBAG	Move on to Step 2	The connector is not correctly connected	Reconnect the connector correctly    See E7030 AIRBAG Delete the errors using the diagnostic equipment and move on to Step 4
2	PRETENSIONER CHECK	All OK	Problems encountered	Operation
	Disconnect the faulty pretensioner from the wiring and connect the simulation resistance in its place    See E7030 AIRBAG Turn the ignition key ON and activate communication with the diagnostic tester. Check whether the fault for that pretensioner has become Intermittent	Move on to Step 3	The fault is still Present	Turn the ignition key OFF.Replace the rear wiring    Op. 5505C40 INTEGRATED PASSENGER COMPARTMENT WIRING - R.R. WITH INTERFERING COMPONENTS REMOVEDDelete the errors using the diagnostic equipment and move on to Step 4
3	FRONT SEAT BELT REPLACEMENT	All OK	Problems encountered	Operation
	Turn the ignition key OFF.Replace the front seat belt with the faulty pretensioner    Op. 7065A12 FRONT SEAT BELT (ONE), LEFT OR RIGHT, WITH PRETENSIONER ON REEL - R.R Clear the errors using the diagnostic tester	Move on to Step 4	-	-
4	CHECK ON CORRECT OPERATION	All OK	Problems encountered	Operation
	Check that the diagnostic equipment is not signalling other faults	End of diagnosis	The diagnostic equipment is signalling other faults	Proceed as instructed in the    See table K080 AIRBAG FAILURE WARNING LIGHT ON