199002903 - B0108 Driver's side airbag resist.

To apply this procedure, the following must be borne in mind:1 - Measurements cannot be taken on the Air Bag wiring.2 - The system fault diagnosis is started leaving the vehicle charges connected.3- The fault should be "Present" or "Present Intermittently" and not "Intermittent". If the fault is Intermittent then the Procedure is not applicable; proceed with an accurate check on the line where the fault was signalled.4 - Not all the simulation sensors are available (e.g. side impact sensors).

The airbag fault warning light is controlled by a dedicated connection to the airbag control unit Instrument Panel Node.

The Air Bag wiring is a safety component. If there are problems with the cables or the connectors then the wiring should be replaced in one piece.

		Test results
1	SIDE BAG CHECK	All OK	Problems encountered	Operation
	Turn the ignition key OFF.Disconnect the faulty side bag from the wiring and connect the simulation resistance in its place    See E7030 AIRBAG Turn the ignition key to the ON position and activate the dialogue with the diagnostic equipment. Check that the fault relating to the Side Bag has become Intermittent	Move on to Step 2	The fault is still Present	Turn the ignition key OFF.Replace the Side Bag wiring    Op. 5580C86 SIDE BAG CABLE LOOM (ONE) LH OR RH - R.R OR REPLACE Delete the errors using the diagnostic equipment and move on to Step 3
2	SIDE BAG REPLACEMENT	All OK	Problems encountered	Operation
	Turn the ignition key OFF.Replace the faulty Side Bag    Op. 5580C44 FRONT SIDE BAG MODULE (ONE) LH OR RH - R.R Clear the errors using the diagnostic tester	Move on to Step 3	-	-
3	CHECK ON CORRECT OPERATION	All OK	Problems encountered	Operation
	Check that the diagnostic equipment is not signalling other faults	End of diagnosis	The diagnostic equipment is signalling other faults	Proceed as instructed in the    See table K080 AIRBAG FAILURE WARNING LIGHT ON