5040A20 AIR CONDITIONER COMPRESSOR - R+R - INCLUDES FLUID LEVEL CHECK AND TOP UP IF NECESSARY - Fiat - DOBLO - eLearn

2584821 - 5040A20 air conditioner compressor - r+r - includes fluid level check and top up if necessary

) Place the car on a lift. Op. 5040A10 AIR CONDITIONING REFRIGERANT CIRCUIT - DRYING AND REPRESSURIZINGDisconnect the battery negative terminal. Op. 4450B04 RIGHT FRONT WHEEL - R.R. Op. 7055B54 PROTECTION/GUARD UNDER ENGINE - R.R. Op. 7055B64 ENGINE COMPARTMENT DUST PROTECTION IN FRONT WHEEL ARCH LINER (ONE) LEFT OR RIGHT - R.R. Op. 1092D10 AIR CONDITIONER COMPRESSOR DRIVE BELT - R + R1. Disconnect the compressor electrical connector.

	Name	Connector
1	Air conditioning compressor "on" electromagnet	See L020 AIR CONDITIONING COMPRESSOR ENGAGEMENT SOLENOID

2. Undo bolt (2a) and disconnect the pipe from the compressor to the condenser, compressor side. Undo the fixing bolt (2b) and disconnect the pipe from the compressor to the expansion valve, compressor side.3. Undo the fixing bolt (3a) and remove the pulley (3b).

Refitting ( Removing

) If the air conditioning compressor is being replaced, proceed as follows.Drain the fluid contained in the compressor through the pipe attachment fittings on the compressor.

Manually rotate the air conditioning compressor to facilitate the removal of all the fluid.

The fluid is extremely hygroscopic: avoid leaving the containers open. Avoid leaving the compressor or any other component disconnected from the system for longer than is strictly necessary.

1. Recover the fluid drained from the compressor in a suitable transparent container (quantity A).2. Drain and recover the fluid from the new compressor (quantity B) in an identical container, following the instructions given previously.3. Introduce the same amount of fluid removed from the compressor being replaced into the new compressor (eliminate quantity C = B - A).

Fit the compressor and tighten the bolts to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	AIR CONDITIONER ASSEMBLY COMPRESSOR	M8 x 85	(fastening to support) 2.5

Connect the electrical connector.

	Name	Connector
-	Air conditioning compressor "on" electromagnet	See L020 AIR CONDITIONING COMPRESSOR ENGAGEMENT SOLENOID

Connect the connection pipes to the expansion valve and condenser to the compressor. secure the fittings with the bolts.

	Fastening	Component	Ø	Value(daNm)
1	Bolt	PIPES FROM COMPRESSOR TO CONDENSOR	M6	(On compressor) 0.9

	Fastening	Component	Ø	Value(daNm)
1	Bolt	INLET LINE TO COMPRESSOR	M6	(on compressor) 0.9

Op. 1092D10 AIR CONDITIONER COMPRESSOR DRIVE BELT - R + R Op. 7055B64 ENGINE COMPARTMENT DUST PROTECTION IN FRONT WHEEL ARCH LINER (ONE) LEFT OR RIGHT - R.R. Op. 7055B54 PROTECTION/GUARD UNDER ENGINE - R.R. Op. 4450B04 RIGHT FRONT WHEEL - R.R.Connect the battery negative terminal. Op. 5040A10 AIR CONDITIONING REFRIGERANT CIRCUIT - DRYING AND REPRESSURIZINGRemove the vehicle from the lift.