2584825 - 5040A50 pipe from compressor to air conditioner condenser - r+r
 Removing
		(
		Refitting
Removing
		(
		Refitting )
	Position the vehicle on a lift.Make sure that the ignition key is in the OFF position, then disconnect the negative battery terminal.
		)
	Position the vehicle on a lift.Make sure that the ignition key is in the OFF position, then disconnect the negative battery terminal.| Description | Connector | |
|---|---|---|
| - | Battery | See A1H BATTERY ( ENGINE ) | 
|  | Seal the connectors that have been disconnected using suitable plugs to prevent dampness and impurities from entering the system. | 


 Refitting
		(
		Removing
Refitting
		(
		Removing )
	1. Refit the pipe from the compressor to the air conditioner compressor (1a) in its seat, connect it to the condenser and tighten bolt (1b) to the specified torque.
		)
	1. Refit the pipe from the compressor to the air conditioner compressor (1a) in its seat, connect it to the condenser and tighten bolt (1b) to the specified torque.|  | Replace any O-Rings for the connectors using green coloured seals only which are resistant to the R134a refrigerant fluid. Lubricate the connector threads using anti-freeze. | 
| Fastening | Component | dia | Value(daNm) | |
|---|---|---|---|---|
| 1b | Bolt | PIPES FROM COMPRESSOR TO CONDENSOR | M6 | (Condenser side) 0.7 - 1.1 | 

|  | Replace any O-Rings for the connectors using green coloured seals only which are resistant to the R134a refrigerant fluid. Lubricate the connector threads using anti-freeze. | 
| Fastening | Component | dia | Value(daNm) | |
|---|---|---|---|---|
| 1b | Bolt | PIPES FROM COMPRESSOR TO CONDENSOR | M6 | (Compressor side) 0.7 - 1.1 | 

| Description | Connector | |
|---|---|---|
| - | Battery | See A1H BATTERY ( ENGINE ) |