2584171 - 1020A20 crank case oil sump - r + r clean seals for sealant application

Removing ( Refitting ) Position the vehicle on a lift.Proceed with the removal    Op. 7055B54 PROTECTION/GUARD UNDER ENGINE - R.R..Proceed with the removal    Op. 2110A60 MANUAL GEARBOX/ENGINE COUPLING BRACKET - R+R.1. Undo the drain plug in the crankcase sump and leave the engine oil to drain into a suitable container.

Do not let the oil disperse into the atmosphere as this could cause pollution.

1. Undo the nuts (1a) and bolts (1b) securing the crankcase sump.2. Cut the crankcase sump sealant using the tool.

	Description	Code
2	Blade	1.870.718.000

3. Remove the crankcase sump. Refitting ( Removing ) Clean the residues of sealan from the matching surfaces between the lower engine block and the crankcase sump.1. Apply a strip of recommended silicon sealant to the contact surfaces between the crankcase sump and lower crankcase as shown in the diagram in the figure.N. A: The sealant strip must be unbroken. The sealant strip diameter must be 3.5 0.5 mm

	Type	Component	Description	Qty.
1	Sealant	ENGINE OIL SUMP	LOCTITE 5900	-

1. Position the crankcase sump (1a) in its housing and secure it tightening the bolts (1b) and the nuts (1c) to the recommended torque.

	Fastening	Component	dia	Value(daNm)
1b	Bolt	ENGINE OIL SUMP	M6	(Lower engine crankcase side) 0.8 - 1.0

	Fastening	Component	dia	Value(daNm)
1c	Nut	ENGINE OIL SUMP	M6	(Cam cover side) 0.8 ÷ 1.0

1. Tighten the drain plug in the crankcase sump to the recommended torque.

	Fastening	Component	dia	Value(daNm)
1	-	ENGINE OIL DRAIN PLUG	M14	(Crankcase sump side) 1.8 - 2.2

Proceed with the refitting    Op. 2110A60 MANUAL GEARBOX/ENGINE COUPLING BRACKET - R+R.Refill the engine oil lubrication system    Op. 0010T11 ENGINE OIL - CHECK LEVEL AND TOP UP.Proceed with the refitting    Op. 7055B54 PROTECTION/GUARD UNDER ENGINE - R.R..Remove the vehicle from the lift.