2710A14 RIGHT HAND DRIVE SHAFT WITH JOINTS - R+R - Fiat - DOBLO - eLearn

2584607 - 2710A14 right hand drive shaft with joints - r+r

) Position the car on the ramp.Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal.Carry out Op. 7055B54 PROTECTION/GUARD UNDER ENGINE - R.R.Carry out Op. 4450B04 RIGHT FRONT WHEEL - R.R.1. Prise up the brake fluid hose to caliper (1a) and wear sensor electrical lead (1b) from the anchorages.2. Remove the security staking and undo the nut fixing the driveshaft to the front wheel hub.

1. Undo the nut (1a) and disconnect the steering link (1b) from the steering knuckle using the tool (1c).

	Name	Country
1c	Head extractor	1.847.035.000

1. Unscrew bolts (1a) securing the front hub knuckle assembly (1b) to shock absorber (1c).

Withdraw the front hub steering knuckle assembly from the driveshaft by turning downward.1. Undo bolts (1a) securing the intermediate driveshaft to mount (1b).

1. Release the right driveshaft (1a), complete with intermediate driveshaft (1b) and remove it.

Recover any gear fluid that emerges from the differential casing in a suitable container.

2. Remove the dust cover from the drive shaft.

Refitting ( Removing

) Fit a dust cover on the drive shaft, differential side.Position the right driveshaft together with the intermediate drive shaft in its seat on the differential, taking the greatest care not to damage the seal.Position the dust cover in its seat on the differential case.1. Screw in the intermediate drive shaft bolts to the mount and tighten to the specified torque.

	Fastening	Component	Ø	Value(daNm)
1	-	-	-	-

Position the pillar/brake disc assembly in its seat.1. Screw in the nuts and tighten them to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1	Nut	FRONT SHOCK ABSORBER . LOWER MOUNTING.	M12 x 1.25	(Steering knuckle side) 12

1. Connect the steering link (1a) to the front steering knuckle and tighten the nut (1b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1b	Nut	POWER STEERNG BOX LINKS	M10	(Wheel damper side) 4.5 ÷ 5.5

Always replace the nut securing the wheel hub to the drive shaft whenever the unit is disassembled.

1. Tighten a new nut f(1a) to secure the front wheel hub to the driveshaft to the recommended torque using the angle tightening tool (1b).

	Fastening	Component	Ø	Value(daNm)
1a	Nut	FRONT SHOCK ABSORBER . LOWER MOUNTING.	M22	(Driveshaft side) 7.0 + 55 °

	Name	Country
1b	Protractor	1.860.942.000

1. Stake the collar of the nut twice as shown in the figure.

Carry out Op. 4450B04 RIGHT FRONT WHEEL - R.R.Carry out Op. 7055B54 PROTECTION/GUARD UNDER ENGINE - R.R.Connect the battery negative terminal.Remove the car from the ramps.